WRF输出变量说明.docxVIP

WRF输出变量说明以下是WRF输出变量的一个翻译，由于不是所有的变量都接触过，也仅仅是就字面意思翻译，所以有的变量的意义难免是不对的（拿不准的，我会用红色标出），因此请用过其中变量的朋友和我一起来完善它：float LU_INDEX(Time, south_north, west_east) ;LU_INDEX:description = LAND USE CATEGORY ;LU_INDEX:units = ;地表类型（如城市、植被、湖泊等）float ZNU(Time, bottom_top) ;ZNU:description = eta values on half (mass) levels ;ZNU:units = ;eta坐标系的值float ZNW(Time, bottom_top_stag) ;ZNW:description = eta values on full (w) levels ;ZNW:units = ;eta坐标系的值float ZS(Time, soil_layers_stag) ;ZS:description = DEPTHS OF CENTERS OF SOIL LAYERS ;ZS:units = m ;土壤层中层的深度float DZS(Time, soil_layers_stag) ;DZS:description = THICKNESSES OF SOIL LAYERS ;DZS:units = m ;土壤层厚度float U(Time, bottom_top, south_north, west_east_stag) ;U:description = x-wind component ;U:units = m s-1 ;纬向风分量float V(Time, bottom_top, south_north_stag, west_east) ;V:description = y-wind component ;V:units = m s-1 ;经向风分量float W(Time, bottom_top_stag, south_north, west_east) ;W:description = z-wind component ;W:units = m s-1 ;垂直风分量float PH(Time, bottom_top_stag, south_north, west_east) ;PH:description = perturbation geopotential ;PH:units = m2 s-2 ;扰动位势float PHB(Time, bottom_top_stag, south_north, west_east) ;PHB:description = base-state geopotential ;PHB:units = m2 s-2 ;平均重力位势float T(Time, bottom_top, south_north, west_east) ;T:description = perturbation potential temperature (theta-t0) ;T:units = K ;扰动位温float MU(Time, south_north, west_east) ;MU:description = perturbation dry air mass in column ;MU:units = Pa ;干空气柱扰动气压float MUB(Time, south_north, west_east) ;MUB:description = base state dry air mass in column ;MUB:units = Pa ;平均干空气柱气压float NEST_POS(Time, south_north, west_east) ;NEST_POS:description = - ;NEST_POS:units = - ;…………………float P(Time, bottom_top, south_north, west_east) ;P:description = perturbation pressure ;P:units = Pa ;扰动气压float PB(Time, bottom_top, south_north, west_east) ;PB:description = BASE STATE PRESSURE ;PB:units = Pa ;平均气压float SR(Time, south_north, west_east) ;SR:description = fraction of frozen precipitation