SIMOVIS使用说明[1].docVIP

SIMOVIS使用说明 SIMOVIS operating instructions 1安装 Installation 打开随机光盘后，进入Simovis(V5.4)文件夹，再进入Windows文件夹，双击，随后按提示安装即可。 Open the random CD-ROM, enter Simovis (V5.4) folder,enter the Windows folder again ,double click setup.exe.and then follow the prompts to install. 2使用 Use 安装完成后，桌面出现图标，双击进入应用程序。 After the installment completes, the tabletop presents the somovis(uss).ink,double- click enter the application procedure. 点击，出现，在Drive下拉表中选择SIMOREG6RA24，然后点击OK。此时为如下画面。 Click+, appeared .Select SIMOREG6RA24, at Drive drop-down table , then click OK. At this point is the following screen. 1.1与调速器的连接Connection with the governor 在“Connect.on/off”下第一个灰色长方条上点击，如变为绿色说明已与调速器连接，如变为黑色，说明未与调速器连接。 Under Connect.on / off , click on a gray rectangle bar, if become the green that has been connected with the governor, if become the black, that is not connected with the governor. 建议：引发这一问题的几种可能性suggested: several kind of possibility cause this question a应检查连接电缆是否正确插紧，接法是否正确。在PC端应接到正确的COM口。在6RA24调速器侧，应接到正确的接口插座X501（RS232接口）。 Should inspect the tie cable whether to insert correctly tightly, the connection way is whether correct. Connect the correct COM mouth in the PC end. In the 6RA24 governor side, correctly connect to the interface socket X501 (the RS232 interface). b调速器的跨接器XJ2，XJ6，XJ7，XJ8均应设置在1-2位置。 The jumper of governor XJ2, XJ6, XJ7, XJ8 should be set at 1-2. position 其余请参考随机手册第15章中15.5节。 Other please refer to the random manual 15th chapter of 15.5. 当首次退出该程序时，会有提示问是否保存该设置，点击“yes”即可，下次运行时，会自动打开该设置。 When exit the program at first time, there will be prompted to ask whether or not to preserve the settings, click yes, then next time movement, will open the setting automatically. . 点击，出现如下画面 Click, the screen appears as follows 2.1上载 Upload 2.1.1要求：此时必须为在线状态，即点击，如果不是在线状态，则相应的菜单命令为灰色，不能被选择。 Request: This time must be on-line state, namely click , if not, the corresponding menu order is gray and can not be selected. 2.1.2操作步骤 Steps a.选择菜单命令File Upread Base unit: all... Select menu order b