后处理构造器明书毕业设计论文外文翻译.doc

外文翻译 Post Builder Help Getting Started Post Builder creates and edits postprocessors.?These postprocessors have three elements, each identified by the base name and one of three extensions.? Assuming your postprocessor name is my_machine_tool, these files would be the following: my_machine_tool.pui Only Post Builder uses this file.?This file contains static information on how to write out the .tcl file.?Although Post does not need this file, it must be present in the same directory as the .tcl and .def files in order to edit your postprocessor. my_machine_tool.tcl This file determines the blocks that need to be output from events that are generating by Post.? This file uses the TCL language. Post Builder completely creates this file every time you save your postprocessor.? Post also uses this file at run time to generate NC code. my_machine_tool.def? This file defines all the static information for the postprocessor.?This includes formats, address and NC blocks.?The format of this file is a special syntax created by NX.?This file is used by Post to postprocess the tool path and generate NC code. By default, Post Builder creates your postprocessor in the directory where you started Post Builder.? Use the Save As option in the file dialog to save your postprocessor in the directory of your choice.? In order to use your postprocessor in NX you must add an entry to your template_post.dat file in your current postprocessor directory. Post Builder supports English dialogs only. Procedures in the Base File NX Post depends heavily on procedures in the ugpost_base.tcl file. This file is located in the mach/postprocessor directory. The system uses it to support the file I/O and other basic functions. This is updated with each NX release, and should not be modified. It is possible to overwrite procedures in this file through tcl programming, but this is not recommended. You can overwrite these procedures with a user created tcl file or by using t