ControlWave系统openBSI培训3.ConfigratureParameter.pptVIP

TImeout Controls (for I/O Expansion Rack) * Bristol Babcock Bristol Babcock 软 件 培 训 OPENBSI -------- Configuration Parameters 使用LocalView/NetView启动 -----------Configuration Parameters Soft Switches 设备的地址 配置的参数应 用到其它节点 允许签名 读配置参数从 NETDEF文件 存储配置参数 到NETDEF文件 从RTU读取 储配置参数 储配置参数 存储到RTU Pocket PC的 特殊选项 Specified as 0 for standard BSAP communications. For EBSAP, can be 0 to 127, specifying which group of 127 nodes this RTU belongs to. Serial Ports(ControlWave) 串口的定义 协议选择的种类 Ports-----Ethernet(ControlWave) 以太网口的定义 IP地址的组态 Ports(ControlWave LP) 串口的定义 协议选择的种类 以太网口的定义 Ports (DPC 3330/3335) 串口的定义 协议选择的种类 以太网口的定义 IP Parameters (DPC 3330/3335) 网络主机的地址 all PCs and RTUs必须有相同的IBP和Time Synch IBP代表the Bristol IP driver 使用的UDP端口号 Time Synch代表RTUs时间同步是使用的UDP端口号 网关 IP Parameters(ControlWave/LP) 网络主机的地址 all PCs and 控制器必须有相同的IBP和Time Synch IBP代表the Bristol IP driver 使用的UDP端口号 Time Synch代表RTUs时间同步是使用的UDP端口号 网关 IP Parameters(ControlWave/LP) RIP: Routing Internet Protocol,支持动态的路由 动态路由的频率 中断时间 网关 重试次数 Appliction Parameters(ControlWave/LP ONLY) 设定CPU为Idle状态的空闲时间百分数。 设定Idle状态最小的空闲时间百分数。 系统idle (default) task执行最小间隔ms Appliction Parameters(ControlWave/LP ONLY) SDRAM Memory (in Kbytes) to allocate for compiled program. Range: 10k to 10240k This is the size of storage space SRAM (in kilobytes) reserved at system start for variables marked as ‘RETAIN’. Range: 0k to 10240k Desired amount of SDRAM (in Kbytes) for program variables. not marked retained and a working area for program data. Range:10k to 10240k. Appliction Parameters(ControlWave/LP ONLY) Specifies the IP address of the port on the A (primary) Specifies the IP address of the port on the B (backup) Power Fail Timeout: This parameter is used to support system startup after power-fail and specifies the power-fail restart interval (Power fail time before jump to safe state). The user can specify one of three methods to handle output state restoration. Based on the timeout value specified, restoring configured outputs will