高级汽车修理工试卷.docVIP

高级汽车修理工试卷4 One, choice question (1 ~ 60. The quantity of the gas state parameter is (). (A) internal energy (B) energy (C) heat (D) pressure In the theoretical cycle of heat mixing, if the ratio of compression to the total quantity of heat is determined, if the pressure is higher than the increase, the heat efficiency (). (A) the change (B) becomes low (C) low (D) before it becomes low The engine compression ratio increases, the inflatable factor (). (A) increases (B) decreases (C) invariant (D) decreases after first enlargement 4. In order to improve the filling coefficient, should reduce the resistance of the air intake system, and the air intake system, the () through the cross section of the youngest, and constantly changing, its maximum flow resistance, should first consider. The (A) carburetor (B) enters the valve (C) inlet pipe (D) air filter 5. In the process of the normal combustion of gasoline engine, () is the main stage of combustion process, the stand or fall of this stage are directly affect the power and the thermal efficiency of the engine. (A) induction period (B) reignation period (D) induction period and reignite period The best ignition Angle increases with the speed of rotation (). (A) decreases (B) invariant (C) increases (D) first decreases The combustion of a petrol engine is apt to happen (). (A) high-load operating condition (B) load condition (C) at low speed and low load condition (C) The main purpose of all forms of diesel combustion chamber is to control (). (A) the heat area (B) of the combustion chamber (B) is A certain compression ratio (C) the temperature and pressure in the combustion chamber of the appropriate eddy and oil film (D) 9. In the combustion process of diesel engine, from the first to produce flame center rapid burning mixture in the cylinder, the pressure inside the cylinder reaches the highest between crankshaft Angle, is called (). (A) ignition period (B) period (C) period (C) Due to the flat change of the Me curve o