高级汽车修理工试卷（Senior Auto Engineer ）.docVIP

高级汽车修理工试卷2（Senior Auto Engineer 2） First, multiple-choice questions (first ~ 60 questions). Choose the correct answer and put the corresponding letters into the brackets in the questions. 1 points for each question. 60 points!): 1. the value measured by a pressure meter is gas. (A) table pressure (B), absolute pressure (C), vacuum (D), atmospheric pressure The theoretical cycle of the 2. diesel engine is higher than the theoretical cycle efficiency of the gasoline engine. (A) mixed heating cycle is more efficient than constant volume heating cycle. (B) diesel engine has higher compression ratio (C) the pre expansion ratio of gasoline engine is zero (D), and the pressure rise ratio of diesel engine is zero 3. the maximum value of the coefficient of inflation of the intake valve is corresponding to the decrease of the speed. (A) late closure angle decreased (B), and late closing angle increased (C) during the opening period, the section area increases (D), while the section area at the opening stage decreases 4. when the engine intake valve opens early and closes at a certain angle, the relationship between the coefficient of charge and the speed changes is (). (A) increases with the increase of speed (B) and decreases with the increase of speed (C) the maximum (D) constant at a certain intermediate speed 5. at the end of the intake process, the pressure in the cylinder is always (). (A) greater than atmospheric pressure (B) equal to atmospheric pressure (C) less than atmospheric pressure (D) is independent of atmospheric pressure 6. compared with the gasoline engine, the mixture of diesel engine is formed in (). (A) intake stroke (B), the entire compression stroke (C) compression stroke end (D) intake and compression stroke The lower the speed at which the maximum torque of the 7. gasoline engine is, the car does not change gears, The potential to overcome resistance. (A) the smaller (B) is not affected by rotational speed (C), the larger (D) general 8. in the load c