外文翻译原文碳酸钙填充有机玻璃板的制备及印刷适性的的研究.docVIP

本科生毕业设计（论文）外文译文 Polymer surface modification and characterization of particulate calcium carbonate fillers 学 院 轻工学院 专 业 印刷工程 导 师 学 生 学 号 2015年6月8日 Polymer surface modification and characterization of particulate calcium carbonate fillers Miao Shui* Department of Chemistry, College of Science, Ningbo University, Ningbo 315211, China Received 16 December 2002; received in revised form 11 June 2003; accepted 26 June 2003 Abstract The efficacy of the surface treatment of particulate fillers depends on the chemical character of the components, on the method and conditions of the treatment, and on the amount of the treating agent. Here, the ultra-fine calcium carbonate is surface treated with 1, 2, 3 and 4 wt.% polyacrylic acid (PAA) synthesized by ourselves, which has strong ionic interaction and is an efficient surface modifier. The PAA coated filler is submitted to the measurement of the surface bonded amount, bonding efficacy, X-ray photoelectron spectroscopy (XPS) and inverse gas chromatography. Maximum efficacy is expected at the monolayer coverage of the surface, which is about 0.6 wt.% according to the calculation based on the way they are aligned and is basically in agreement with the ‘‘substrate overlayer’’ model based on the mole ratio of C286 and C290 taking no account of the possible underestimation because of the inaccuracy or because of the CHx contamination present originally on the CaCO3. The initial decrease of the mole ratio of C290/O and C290/Ca with the surface bonded PAA may indicate that the bonding interaction between the polymer and the filler surface is the leaving of one molecular carbon dioxide. The IGC measurement shows that there is a considerable surface tension falling in the case of the PAA modified filler compared with the reference. An abnormal high surface energy in the case of filler treated with 4% PAA is observed. 2003 Elsevier B.V. All rig