储罐双向子午线网壳顶安装要领书（下蒙皮）中英文.docVIP

储罐双向子午线网壳顶 安装要领书（下蒙皮） Double Directional meridian dome roof Installation guidebook Document No.: CM-XXX-0810-0002 油罐直径： 36m Tank Diameter: 36m 曲率半径： 54m Curve Radius: 54 m 设计正压： +5600 Pa Design Pressure(positive): +5600 Pa 设计负压： - 1200 Pa Design Pressure(vacuum): - 1200 Pa  （一）双向子午线网壳的结构特点(characteristic of Double Directional Meridian Dome roof) 1．网壳主体由球面上分别以X轴及以Z轴为旋转轴的两组子午线相交而成。用作罐顶结构的部分是球心角2α=38.942°所对应的球冠，如图一所示。 2．网杆全部采用不等边角钢∠140×90×10，材质为Q235-B。两组子午线网杆间采用连续满角焊，如图二所示。 3．边环梁是网壳的沿边构件，将罐壁与罐顶连成整体。本设计的边环梁由一圈厚度为30mm、宽度为400mm的锥面板，材质为16MnR及角钢圈梁∠160×100×14（材质为Q235-B）组成。如图三所示 4．每道网杆的两端，采用垫板将网杆与边环梁连成一体,材质为Q235-B。 5．蒙皮，对油罐起密封及传递荷载的作用，蒙皮必须使用平整的钢板，沿着与X轴及Z轴成45°角的方向铺设，采用“人字形排板”。 蒙皮材质为Q235-B，板厚为5.5mm。蒙皮板的宽度以能够达到（十一）检验中3的要求为合格。为防止储液凝液结到网杆上，将蒙皮紧贴在网壳结构的下表面，并将蒙皮与下层网杆焊成整体 The roof frame is made of two group of Meridians on spheric surface. One group of Meridians rotate around axis X,and another group of Meridians rotate around axis Z .And the corresponding sphere centre angle of the roof is2α=38.942°,please see figure 1. All girder beams are made of angle L140×90×10,whose material is Q235-B.The two groups of Meridian beams should be continuously fillet-welded .(see figure 2.) Circumference girder are the skirt components,which link the roof and shell together.Circumference girder is a ring of cone face plate with thickness of 30mm,width of 400mm,material of 16MnR and L160?100?14 Q235-B. The beam node connection member in the two ends of girder beam conncet the girder beam, Circumference girder and tank shell together. Connection members are made of 8mm steel plate of Q235-B. Roof plates which seal the tank transfer the stress of load,must be made of flat and smooth plates,be laid along the direction keeping a angle of 45° with axis X0 and axis Z0 .The plates should be rectangular shape.The material of roof plate is Q235-B,thickness is 5.5mm. The width of the roof plate is deomed acceptable when meets with the requi