火灾自动报警及消联动控制系统的施工技术.docVIP

火灾自动报警及消防联动控制系统的施工技术 火灾自动报警及消防联动控制系统的施工技术 火灾自动报警及消防联动控制系统的施工技术 火灾自动报警及消防联动控制系统的施工技术 Automatic fire alarm and fire linkage control system of the construction technology 火灾探测器安装 fire detector is installed 　　火灾探测器按结构分为两类:点型和线型。点型火灾探测器的安装位置、方向和接线方式都要正确。内部接线要可靠，固定要牢固美观。线型火灾探测器和可燃气体探测器等有特殊安装要求的探测器应符合有关标准的规定，且符合产品说明书的要求。 Fire detector according to the structure is divided into two categories: point type and line type. Point type of fire detector installation location, direction, and connection mode should be correct. Internal wiring to reliable, fixed is strong and beautiful. Linear detector and combustible gas detectors and other detectors with special installation requirements shall comply with relevant standards, and meet the requirements of the product data sheet. 手动火灾报警按钮安装 installation manual fire alarm button 　　手动火灾报警按钮安装在建筑物内的安全出口、安全楼梯口等便于操作的部位。有消火栓的建筑物，应尽量设置在靠近消火消火栓的位置。若安装在墙上距地面高度应符合规范要求。 Manual fire alarm button installed in buildings is easy to operate the safety exports, stairs, etc. Fire hydrant buildings, should be set near the location of the fire hydrant. If the installation on the wall height from ground should comply with the specification requirements. 接口模块安装，火灾报警控制器安装，消防控制设备的安装 interface module installed, install fire alarm controller, fire control equipment installation 　　安装前应进行功能检查，检查消防控制设备的外接导线，当采用金属软管作套管时，其长度、管卡固定、固定点间距应符合规范要求，并应根据配管规定接地。消防控制外接导线的端 Should carry on the function check before installation, check the fire control equipment of the external conductor, when metal hose for casing is used, the length, pipe clamp is fixed, fixed point spacing should comply with the specification requirements, and should be according to the regulations of piping grounding. Fire control external end of the wire 　　部、消防控制设备盘内不同电压等级、不同电流类别的端子应分开，并有明显标志。 Department, fire control equipment (categories of different voltage grade and current terminals should be separate, and has the obvious mark. 电梯安装工程的施工技术要点 the elevator installation project construction tec