msc-fatigue-实例-组件的疲劳分析.docVIP

Chapter 4: Component S-N Analysis MSC Fatigue QuickStart Guide 4 Component S-N Analysis ? ? ? ? ? ? Problem Description 138 Geometry 139 Set Up the Fatigue Analysis 142 Run the Fatigue Analysis 158 Review the Results 159 Concluding Remarks 164  138 MSC Fatigue QuickStart Guide Problem Description Problem Description A simple bracket as shown has a design life of 7 years (61,320 hours). Loading occurs at the end of the short section which has been welded and the component is constrained at both ends of the main bar. Because failure is known to occur at the weld, the finite element modeling at the loading point and the stresses found there can be ignored for the purposes of this exercise. The load applied in the model was 900 lbs total. In service, the component experiences loading of 3000 lbs in the direction of the finite element load and 7000 lbs in the reverse direction. This occurs once every 30 minutes. Only a 4% failure rate is allowed. Objective ? To introduce the concept of a component S-N curve. ? To learn how to enter materials data into the database manager. ? To determine if the component achieves its design life. ? To determine what level of loading can be achieve and what failure rate could be expected - a sensitivity study. ? To understand what files are created by an MSC Fatigue analysis. Table 4-1 Chapter 4 Necessary Files File P3_HOME/mscfatigue_files/examples/bracket.op2  Chapter 4: Component S-N Analysis 139 Geometry Geometry Invoke MSC Patran as you did in the previous examples. The geometry can be found in the file bracket.op2. The results are from MSC Nastran. Copy the file to your working directory. Open a new database in a clean, empty work directory from the File | New menu. Give the name bracket to the database. Import the Model and Results Press the Analysis toggle switch or tab on the main form. When the form appears set the Action to Access Results, the Object to Read Output2, and