FIR Filter Design amp; ImplementationFIR滤波器的设计与实现；.pptVIP

FIR Filter Design Implementation To fully design and implement a filter five steps are required: (1) Filter specification (2) Coefficient calculation (3) Structure selection (4) Simulation (optional) (5) Implementation Software Tools for Designing Filter MATLAB provides some advanced tools for filters design Signal Processing Tool (SPTool) Filter Design (FDATool) There are also some free software packages to design filters Our main problem is how to implement the filter given the coefficients So we will design FIR filters using the relatively simple method of Windowing -- write Matlab scripts Lowpass Filter Specification Window Method : Step 1 First stage of this method is to calculate the coefficients of the ideal filter. This is calculated as follows: Window Method : Step 2 Second stage of this method is to select a window function based on the passband or attenuation specifications, then determine the filter length based on the required width of the transition band Window Type Normalized Transition Width Passband Ripple (dB) Stopband Attenuation (dB) Rectangular 0.9/N 0.7416 21 Hanning 3.1/N 0.0546 44 Hamming 3.3/N 0.0194 53 Blackman 5.5/N 0.0017 74 Window Method : Step 2 The normalized transition bandwidth as listed in the table is defined as Example: If we choose the Hamming window, and specify a transition band from 6kHz to 7kHz, with sampling frequency at 40kHz, then the filter order is calculated as Window Method : Step 3 The third stage is to calculate the set of truncated or windowed impulse response coefficients, h[n]: for Using Matlabs fir1() Instead of doing the design start from the ideal reponse, we shall use Matlabs fir1() function We will design a FIR filter with the following specification sampling frequency = 8000 passband edge frequency = 1200 stopband edge frequency = 1800 minimum stopband attenuation = 40 dB By using the Hamming window, the stopband attenuation specification is met By default, fir1() uses the Hamming window For m