E接口配置（E interface configuration）.docVIP

E1接口配置（E1 interface configuration） The E1 interface can have two configurations: L is used as a channelized (Channelized) E1 interface. In the physical interface is divided into 31 time slots, all the slots can be arbitrarily divided into several groups, each time slot after use bundled as an interface, the logic is the same as the synchronous serial port, support PPP, LAPB, frame relay and X.25 link layer protocol. L is used as a non channelized (Unchannelized) E1 interface. The interface acts as a G.703 synchronous serial port of 2M at physical rate, and supports link layer protocols such as PPP, frame relay, LAPB and X.25. E1 interface configuration To configure the E1 interface, you must first enter the controller E1 command in the global configuration state. command Effect Controller E1 slot/group Configuring the E1 interface Slot is the slot number at which the E1 controller is located, Group is the link number for the E1 controller. Note: the E1 controller in the 3700 series router is controller E1 0/0, and the 5000 Series router has an E1 controller, the link number range is 0-0, and for the four port E1 controller, the link number range is 0-3. The E1 controller slot number is 1-4. Give an example： Router_config#controller E1 0/0 Router_config_controller_E1_0/0# The configuration tasks for the E1 interface include: L configure the physical parameters of the E1 interface, including frame check mode, line codec format and line clock, loopback transmission mode, and so on. The default parameter is generally used. L channelization (Channelized) E1 interface requires configuration of channel-group parameters and determination of slot binding methods. The L non channelized (Unchannelized) E1 interface does not need to configure the channel-group parameter. L configuration interface (Interface) parameter, Configure how the E1 interface works The E1 interface defaults to channelized (Channelized) mode. It can be set to non channelized (Unchannelized) mode via the u