半直驱风力发电.docVIP

半直驱风力发电机总装配工艺守则Main assembly specification for semi-gear wind generator适用范围 ???????????????????????????本守则适用于半直驱风力发电机PRM1350-1650总装配。????????????????????????????????????????????????????????????????????????????????????????????????????引用文件????????????????DB1143 产品零部件和装配工作场地清洁度规范??????????????????????????????????????????????????????DBG08.10 定置管理办法?????????????????????DB1591 半直驱风力发电机涂漆规范??????????????????????????????????????????????3. 基本要求 ??????????????????所有工装、工位器具、工件及材料用品应归类划区、定置摆放。????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????3.1 材料 ??????????螺纹锁固剂“乐泰”243、塑料布、普通粘胶带、白布。???????????????????????????????????????????????????????????????????????????????????????????????????????设备及工装 ??????????????????? 吊车、平头千斤顶、反磁钢垫条、胶带、轴承安装专用工具。???????????????????????????????????????????????????????????????????????????, appropriative tools for axletree installation通风 ??????????? 无特殊要求 No special require.???????安全 ?????????参与总装配的人员,身上不得有任何磁性物质,包括磁卡、存折、手表、手机、钥匙、金属扣皮带、金属钮扣、金属拉链。????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????????废物处理 ????????????????废物应放入指定的收集箱或容器内。?????????????????????????????????????????????????????????????????????工艺准备 ?????????????????????各零部件必须有合格证才能进行装配。???????????????????????????????????????????????????????????????????????????????准备清理前后端轴承部分的各零部件和把合螺栓，去除油渍（用QX-2清洗剂或其它同类清洗剂清理）Prepare to clean each part which in on both front and back end of the pillow and combined bolt to make them no smeary.(Using QX-2 detergent or other congeneric detergent when cleaning)4.3 用塑料布包裹已装好磁钢的转子外圆，并用胶带固定。将专用的木板放在转子支架侧面的扇形板上，以供装配轴承时踩踏之用。Use plastic cloth to pack rotor’s excirle which has assembled the magnets,zhen fix it by rubber belt.Put approprative board on the fan-shaped board which is on the side of rotor plank to use for trample during pillow assembly.从工装