毕业设计（论文)会泽铅锌矿3000吨日选矿厂初步设计.docVIP

PAGE VI摘 要按照毕业设计任务书的要求，进行了会泽铅锌矿3000吨/日选矿厂初步设计，产品为铅精矿和锌精矿。本文在云南省曲靖市会泽铅锌选矿厂收集相关设计资料的基础上，确定了各车间的工作制度，对设计工艺流程进行了选择和论证，确定了设计的工艺流程，即：破碎采用三段半开路流程，磨矿采用两段闭路流程，浮选采用优先浮工艺，精矿采用先浓缩后过滤的两段脱水。对设计工艺流程进行了工艺指标计算，包括破碎、筛分、磨矿、浮选（包括矿浆流程）和脱水流程。对破碎、筛分、磨矿、分级、浮选及脱水设备进行了选择计算和方案比较，确定了工艺所需的工艺设备。进行了厂房总体布置，并进行了厂房内的设备配置。根据选厂房的地形条件，沿山坡地布置，其中，粗碎、中细碎、筛分厂房分开布置，粗碎、中细碎及筛分车间平行等高线配置。磨矿浮选共厂房配置，其中磨矿采用纵向配置，浮选机采用横向配置。浓缩机配置在露天，过滤机与精矿仓配置在厂房内。完成了粗碎、中细碎、筛分、磨浮、总平面图、数质量流程图和设备联系图共8张。 关键词：选矿厂设计 铅锌矿 浮选 工艺流程 AbstractAccording to the requirements of the design plan descriptions of the graduation,the Hui-Ze lead-zinc mine 3000 tons/day concentrator preliminary design, product for lead concentrates, zinc concentrate and zinc concentrate.This article in Qu-Jing city, Yun-Nan province, Hui-Ze lead-zinc concentrator, on the basis of relevant design information collection, determines the working system of each workshop design process for the selection and reasoning, to determine the design process, namely: three and a half open flow used in the crushing and grinding by using two section closed circuit process, flotation using priority floating craft, concentrate using the concentration filtration dehydration two pieces first.Technological parameters of crushing,screening, grinding ,floation(include the circuit of pulp)and dewatering were computed, respectively. Then the technological parameters of equipments were computed and the schemes of equipments were compared and the optimal equipments were determined. The general arrangement of concentrator plant and the allocation of equipments in diferent workshop were presented. According to the topography of plant site, plants were arranged along the slope of mountain. The workshops of coarse crushing, middle and fine crushing and screening were laid out independent with parallel contour line of coarse crushing workshop middle and fine crushing and screening workshops were used. The workshops of grinding and flotation were put togather, and the longitudinal and lateral plans w