标施工组织设计方案文字说明.docVIP

2.2.3 本标段主线桥梁上部构造的梁体分别是25m、40m后张预应力T梁，立交桥梁上部构造的梁体分别是25m后张预应力箱梁、30m后张预应力T梁以及现浇连续箱梁。根据现场实际情况，分别在每座桥的桥头处设置预制场，待桥头路基基本成型后开始预制，预制底座数量根据预制梁片量和工期要求设置。预制梁模板用定型大块钢模。预制梁运输用轨道平车运输，用架桥机安装。现浇连续箱梁采用满堂支架现浇。 2.2.3.2.4. Bridge Superstructure Construction ??? The main line bridge tenders of the upper structure of the beam is 25 m, 40m post-tensioned T-beam, the upper beam overpass structure of the beam is 25 m post-tensioned box girder, 30 m post-tensioned T-beam and continuous cast-in-place Box Girder. In accordance with the actual situation at the scene, in each bridge to install prefabricated bridge market, to be the bridge roadbed basically shaped after the prefabricated, according to the number of prefabricated base of precast beam films and Time requested. Liang template using prefabricated stereotypes massive steel form. Rail transport using precast beam flat car transport, use bridging machine installation. Continuous use of cast-in-place box girder stent packed cast-in-place. 2.2.3.2.4.1 预制梁施工与安装 1.后张法梁体预制： ①.底模制作 将计划设置的预制场的场地先给以平整规划，而后按规划位置和设计尺寸预制底模。底模中间基础采C20素砼浇灌，底座顶面铺设1cm厚钢板，于起吊位置设活动底模，便于起吊运输。 2.2.3.2.4.1 precast beam construction and installation 1. Post-beam of prefabricated: ①. Die at the end of the production Plans to set up prefabricated field venue to leveling plan given first, then the planning and design position at the end of prefabricated modulus size. At the end of intermediate modulus based mining C20-concrete watering, the base of the top plate laying 1 cm thick, in lifting the position of the end of Die activities, facilitate the lifting transport. ②.绑扎钢筋 钢筋在加工场统一加工，然后运到现场绑扎成型。绑扎时要根据预应力管道的规格，按照钢绞线设计横、竖坐标准确定位波纹管位置，中间接头处要严密包裹，以防脱落、漏浆。最后在两侧绑扎砼保护层垫块。 ②. Banding Reinforced Reinforced in processing unified processing, then transported to the scene banding molding. Banding prestressed pipeline, according to the specifications, according to Strand design horizontal, vertical coordinates accurate positioning Bellows location, close to the middle connector p