rbs2206设备介绍.pptVIP

* LAPD: Link Access Procedures on D-channel. LAPD is the data link layer (Layer 2) protocol used for communication between the BSC and the BTS on the Abis interface. Abis layer 2 is sometimes used synonymously with LAPD. LAPD configuration Unconcentrated 3 TRU/PCM-timeslot = 10 TRU/PCM-link Concentration 2,25 TRU/PCM-timeslot = 13 TRU/PCM-link Multiplexing 2 TRU/PCM-timeslot = 15 TRU/PCM-link (max 2 TRU/cell ) TG: Transceiver Group TG synchronization is the technology used to expand one RBS 2206 cabinet with another RBS cabinet in the same cell. The task of TG synchronization is to keep TGs within a cluster synchronized. This synchronization is done by exchanging timing information via an ESB cable. * Flash Memory Card( Compact Flash Card) All loadable software and the IDB are stored on this card. The cards contains all information for configuring replacement units if RBS 2206s are exchanged. * DXU-21A无ECOM接口 T1, 1.5Mbit/s, 100Ohm E1, 2Mbit/s, 120Ohm E1, 2Mbit/s, 75Ohm * The dTRU has a unique feature called TCC (Transceiver Coherent Combining) that provides an extended cell radius for the downlink. TCC mode means that the same signal is transmitted through both transceivers in the dTRU and the signals are added coherently in a hybrid combiner inside the dTRU. The result is an output signal with twice the maximum power provided by a single TRX. * A hybrid combiner is included inside the dTRU. The hybrid combiner is used together with CDU-G to increase the number of TRXs per antenna. It is possible to by-pass the hybrid combiner by re-cabling the connection to the CDU. CDU-F可以测量VSWR,VSWR告警设为1.8-2.2,通常为1.2以下 * CDU-F in a configuration with 12 TRXs(6 dTRUs) in one sector * * CDU-G天馈连接头 与CDU-F天馈接口相比, CDU-G的两个接口都可以用做收发 CDU-G天馈配置 3×2 CDU-G或3×4CDU-G配置连接图,即3个小区,每个小区2个或4个载波的配置 配置交换单元的任务是交叉连接CDU和dTRU之间接收路径.配置交换单元使得尽可能少地移动或替换接收线缆的前提下,扩展或重新配置机柜 CDU和dTRU接收端的输入输出的摆放位置尽可能地减少了连接CXU和CDU/dTRU线缆的类型 配置交换单元(CXU) 配置交换单元方框图 连dTRU端 连CDU端 配置交换单元实际连接图 基站主设备总线 Y link总线 D