通用GE瓦克清洁度标准.docVIP

PAGE PAGE 1 QUALITY SYSTEM DOCUMENTATION Document No. STD-02-0860 Page of NUMPAGES \* Arabic \* MERGEFORMAT 9 Revision No. 03 Revision Date 8/5/2009 Title: PART CLEANLINESS STANDARD零件清洁标准 PAGE Prepared By: Ronald Mrazek, _______________________________________________________Date: 8/5/2009___________ Approved By: Andrew Green_________________________________________________________Date: 8/5/2009 NOTE: The most recent changes are indicated in red with a revision bar in the margin to the left of the change. NOTE: Hard copies of any section, form and/or attachment contained in this document are considered uncontrolled and out of date As soon as they are printed. UNSIGNED DOCUMENT INDICATES UNCONTROLLED COPY. Form 0019S 3/2005 PAGE QUALITY SYSTEM DOCUMENTATION Document No. STD-02-0860 Page PAGE 9 of NUMPAGES 10 Revision No. 03 Revision Date 8/5/2009 Title: PART CLEANLINESS STANDARD NOTE: The most recent changes are indicated in red with a revision bar in the margin to the left of the change. NOTE: Hard copies of any section, form and/or attachment contained in this document are considered uncontrolled and out of date as soon as they are printed. UNSIGNED DOCUMENT INDICATES UNCONTROLLED COPY. Form 0019S 3/2005 1.0 PURPOSE 目的 The purpose of this standard is to define the part cleanliness requirement goals for engine ready components. Component cleanliness directly correlates to break in damage and long term reliability. 此标准目的是说明零件清洁要求目标.组件清洁度直接关联损坏和长期的可靠性 SCOPE范围 This procedure applies to all purchased and manufactured parts that are ready for assembly into an engine. This standard supersedes all other cleanliness requirements. If this standard conflicts with any cited reference, this standard takes precedence. This standard does not apply to rough castings or components in process.此程序应用于所有的组装到一个发动机里的购买和生产的零件.此规范代替所有其他的清洁度要求.如果此标准和任何引用参考冲突.适用此规范.此规范不适用毛坯铸件或组件. The sampling procedures are defined in DWI-05-8575.取样程序定义在DWI-05-