毕业论文(设计)-《电力电子电路典型环节的MATLAB仿真》.docVIP

PAGE PAGE I l 教学单位 电子电气工程系 教学单位 电子电气工程系 学生学号 200895014075 编 号 DQ2012DQ075 本科毕业设计 题　　目　 　 学生姓名　　 　　　　 专业名称　 　 指导教师　　　 　　　 年　　月　　日 PAGE PAGE 1 电力电子电路典型环节的MATLAB仿真 摘 要:本文主要研究了电力电子电路典型环节的MATLAB仿真，首先介绍了MATLAB软件及其图形仿真界面Simulink的基础应用知识，然后介绍了用于电力电子仿真的SimPowerSystems中的各种模块库，完成了对整流电路、斩波电路典型环节的建模与仿真，并且给出了仿真结果波形。 通过MATLAB/SIMULINK软件来建立各电路的仿真模型，并且对各个模块和系统内部的参数进行设置，例如仿真算法、电子器件的选择和电源幅值和频率等，最终实现电力电子系统在MATLAB中的仿真。仿真结果和理论分析结果相一致，验证了仿真建模的有效性和正确性。 最后，本文对研究成果进行了总结，并提出了进一步改进建议。 关键词：Matlab/Simulink，仿真，整流电路，斩波电路 Abstract:This paper mainly studies the MATLAB simulation of the typical session to the power electronic circuit, This article first introduces the MATLAB software and the application of knowledge based on graphical interface Simulink simulation, and then introduced the various modules of SimPowerSystems library for the power electronic simulation, also completed Modeling and Simulation to the typical session of rectifier circuit and Chopper circuit, and show the results of the simulation waveform. Established various electric circuits through MATLAB/SIMULINK software the simulation model, and set the establishment to each module and the interior parameter of system, for example simulation algorithm, electronic device choice and electrical source peak-to-peak value and frequency and so on, finally realized simulation that the electric power electronics alternating-current circuit in MATLAB. Simulation result and theoretical analysis result consistent, has confirmed the simulation modelling validity and the accuracy. Finally, this paper summarizes the research results and makes suggestions for further improvement. Keywords: Matlab/Simulink , Simulation, Rectifier circuit, Chopper circuit 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc325322374 第1章 概述 PAGEREF _Toc325322374 \h 5 HYPERLINK \l _Toc325322375 1.1 国内外研究概况 PAGEREF _Toc325322375 \h 5 HYPERLINK \l _Toc325322376