eetop.cn_【ISE TCAD】Diode process and simulation.pptVIP

* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * Use “Inspect” to check IV curve (1) Use “Inspect” to check IV curve (2) Step 1 : click /Pplus/OuterVoltage/To X-axis Step 2 : click /Pplus/TotalCurrent/To Left Y-axis Step 1 Step 2 Device Characteristic Extraction : Inspect DESSIS : Add “Inspect” tool and edit input file Step 1: “Right click” on “Dessis” icon Step 2: “Right click” on “Inspect” icon Inspect input file “inspect_ins.cmd” set out_file n@previous@_des proj_load ${out_file}.plt # # # 1) Create IV curve # # # cv_create iv ${out_file} Pplus OuterVoltage ${out_file} Pplus TotalCurrent cv_write xgraph n@node@_plc.plt iv # # # 2) VT extracted # # # set VT1 [ expr ([f_VT iv] ) ] ft_scalar VT [format %1.3f $VT1] exit Run “Inspect” The Vt=“0.675” is shown after running “inspect” Check IV curve Summary File structure Command file dios_dio.cmd mdraw_mdr.cmd dessis_des.cmd inspect_ins.cmd Input file Output file n1_dio.grd.gzn1_dio.dat.gzn1_mdr.bnd n1_dio.cmd n2_mdr.cmdn2_mdr.bnd n2_mdr.grdn2_mdr.dat n3_des.cmd n4_ins.cmd n3_des.pltn3_des.dat Summary There are seven tools in this Examples GENESIS : The integration environment for TCAD simulation Ligament : The Graphic edit interface for Process simulation DIOS : The Process simulation tools Mdraw : The Graphic edit interface for Mesh definition Dessis : The Device simulation tools Inspect : Check 1D graphic and device characteristic extraction Tecplot : Check 1D/2D/3D graphic * * * * * * * * * * * * * * * * * * * * * * Run Dios Project Step 1 : Click this Step 2 : Click this On running DIOS Click this to show mesh Click this to break the “DIOS” executing Use “Inspect” to see the 1D profile (1) Use “Inspect” to check 1D profile (2) click “middle” button to move Legend Zoom in the picture, Use “Left” button select one rectangle range Switch Y-axis