基于OP07的测量放大器的设计（毕业学术论文设计）.docVIP

本科毕业论文（设计） 题 目: 基于OP07的测量放大器的设计 院 系：物理与电子信息科学系 专 业：电子信息科学与技术 姓 名：XXXXXXXXXX 学 号：XXXXXXXXXXXXX 指导教师：XXX 教师职称：副教授 填写日期：2010年5月26日  摘 要 放大器是电子系统的重要组成部分，了解和掌握放大器对于学习和应用电子系统有很大的帮助。信号检测中的放大电路有很多种类型，实际系统中常采用的有测量放大器和隔离放大器。放大器及其所用的稳压电源两个两性能（主要指输入阻抗、共模抑制比和开环增益）一致稳压电源  Abstract Amplifier is an important component of electronic systems; it is benefit to study and apply for the electronic systems by understanding and mastering knowledge of amplifiers. There are many types of signal detection amplifier, measurement amplifiers and isolation amplifiers are often used in real systems. Measuring amplifier is mainly achieved on the micro-signal measurements, to achieve the amplification of weak voltage signal. The graduation project is to design a measuring amplifier and power supply used. Measuring amplifier, the first-class circuit more common by the two integrated operational amplifier OP07 with parallel access to form a dynamic amplifier with a difference, can effectively suppress common mode signals, increase common-mode rejection. Requested the two integrated operational amplifier performance (mainly the input impedance, common mode rejection ratio and open loop gain) line, so that in addition to differential mode circuit, common mode input resistance characteristics of large, the two op amps common-mode gain, offset and drift errors resulting offset each other. Second Level Differential amplifier circuit in parallel with the integrated transfer after Afterwards an OP07, the purpose is to cut the common-mode signal transmission, to achieve double-ended output variable single-ended output. To meet the ground load requirements. Finally, the output termination of a potentiometer, simulation, through the regulation of the potentiometer, to realize the voltage gain changes. Regulated power supply circuit used for the op amp power supply, this power supply circuit desi