串联臂压电微电机及驱动电源的探究.pdfVIP

第 22 卷第 5 期　　　　　　　　　　　　仪　器　仪　表　学　报　　　　　　　　　　　2001 年 10 月 串联臂压电微电机及驱动电源的研究 梁克平　邵培革　杨敬涵　王立鼎 (大连理工大学机械工程学院　大连　116024) ( ) 摘要　二级串联压电双晶片 串联臂 一端固定时, 在相位差为 2 的偏置方波信号驱动下, 自由端将沿椭圆轨迹运动。以串联臂为 驱动元件, 可用来驱动端面与其相接触的转子转动, 构成串联臂压电微电机。对单路方波信号分频, 可产生双路相位差为 2 的方波 信号, 对信号进行放大, 构成相位差为 2 的偏置方波驱动信号。 关键词　压　电　串联弯曲臂　驱动电路 D r iv ing M echan ism and the D r iv ing C ircuit of a M icrom otor D r iven by Ser ies Bend ing V ibra ting P iezoelectr ic Arm s 　 　 　 L iang Kep ing Shao Peige Yang J inghan W ang L iding (Colleg e of M echanical E ng ineering , D alian U niv. of T echnology , D alian 　116024, Ch ina) Abstract　 2, ( D riven by two signals of biased bar w ith phase difference of the free end of a cantilever nam ed as se ries bending arm ) compo sed of two series p iezoelectric bimo rph s w ill move along an ellip tic o rbit w hen the o ther end is fixed. W hen the cantilever is used to drive a cylinder ro tato r, of w h ich the end surface contact the free end of the can tilever, the ro tato r w ill ro tate. T hus a m icromo to r driven by cantilevers compo sed of series p iezoelectric bimo rph s can . , be m anufactured W hen one bar signal is p rocessed w ith frequency division two bar si