基于单片机的SD卡录音笔设计与实现_毕业设计论文.doc.doc

PAGE 基于单片机的SD卡录音笔设计与实现 摘 要 本文介绍的是基于单片机的SD卡录音笔的设计与实现。首先介绍了SD卡和SPCE061A的技术应用，发展趋势和研究意义；然后深入分析了单片机录音笔的基本原理，同时全面介绍了实现基于单片机的SD卡录音笔所需要的硬件和软件；接下来是详细介绍了实现基于单片机的SD卡录音笔的硬件电路设计以及软件结构设计；最后对整个系统的性能进行测试和分析。 整个系统分为硬件设计和软件设计两大模块。硬件部分由凌阳公司的SPCE061A单片机，扬声器，电池组等构成；软件环境选择的是与硬件配套的u’nsp IDE 2.0.0。本系统能够实现对声音的多段录音、放音、删除等功能。 关键词：μ’nSP IDE，SPCE061A，SD卡，录音笔 Microcontroller-based SD Card Recorder Design Abstract This article is based on the SD Card Recorder MCU Design and Implementation. First introduced the SD card and SPCE061A of technology, trends and research significance; then analyzed in depth the basic principles of single chip voice recorder, while achieving a comprehensive introduction to microcontroller-based SD Card Recorder necessary hardware and software; followed by implementation details of the microcontroller-based SD Card Recorder hardware circuit design and software architecture design; Finally, overall system performance testing and analysis. The whole system is divided into two major hardware and software design module. Hardware used by the microcontroller control chip Sunpluss SPCE061A development board, speaker, battery pack; software environment and hardware choices are supporting unsp IDE 2.0.0. The system can realize the multi sound recording, playback, delete and so on. Keyword: μ’nSP IDE,SPCE061A,SD Card,Recorde PAGE IV 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc21406 1 绪论 PAGEREF _Toc21406 1 HYPERLINK \l _Toc28020 1.1 SD卡录音笔概论 PAGEREF _Toc28020 1 HYPERLINK \l _Toc19199 1.2 录音器的发展历史 PAGEREF _Toc19199 3 HYPERLINK \l _Toc26218 1.2.1 留声机 PAGEREF _Toc26218 3 HYPERLINK \l _Toc6258 1.2.2 钢丝录音和磁带 PAGEREF _Toc6258 3 HYPERLINK \l _Toc21555 1.2.3 数码录音笔 PAGEREF _Toc21555 4 HYPERLINK \l _Toc20311 1.3 SD卡录音笔的发展趋势 PAGEREF _Toc20311 5 HYPERLINK \l _Toc9956 1.3.1 提高录音质量 PAGEREF _Toc9956 5 HYPERLINK \l _Toc2239 1.3.2 多功能于一身 PAGEREF _Toc2239 5 HYPERLINK \l _Toc8026 1.3.3 降低成本减小体积 PAGEREF _Toc8026 5 HYPERLINK \l _Toc1528 1.4 基于单片机的SD卡录音笔研究意义