《单块非平面环形腔激光器》-毕业学术论文设计.docVIP

单块非平面环形腔激光器的数值模拟与实验研究 中文摘要 单块非平面环形腔激光器将传统激光器中的激光增益介质与光学共振腔集成到单块晶体上，具有结构紧凑、工作性能非常稳定的优点，可以输出光束质量好、相干长度长、谱线宽度窄、单色性好的激光。该型激光器通常采用半导体激光器端面泵浦，可以将泵浦光以较小损失经由聚光系统耦合进激光晶体中，同时泵浦光的模式与振荡光的模式匹配效果好，因而增益介质对泵浦光的利用率相对较高。 本文采用琼斯矩阵分析腔内传输光的偏振态，编制程序计算两个相反环向传输光之间的损耗差及最小损耗，然后利用该程序设计一个理论上可行的单块非平面环形腔激光器。实验部分，测试了输出波长分别为1064nm和1319nm的Nd:YAG单块非平面环形腔激光器，探讨了各项参数对该型激光器的影响，为实际设计制造该种激光器打好实践基础。 关键词:单块非平面环形腔，端面泵浦，琼斯矩阵 Abstract Monolithic non-planar ring laser integrates the laser gain medium and optical resonator used in the traditional laser into monolithic crystal, which has the advantages of compactness and stable performance. And the output of this kind of laser has the advantages of excellent beam quality, long coherence length, narrow line width and good monochromatic. This kind of laser is usually end-pumped by semiconductor laser, in this way the pumping beam can be coupled into gain medium by condenser system at a little loss. At the other hand, the pattern matching of pumping light and oscillating light is effective, so the utilization coefficient of pumping light is relatively high in the gain medium. This article will use Jones matrix to analyze the polarization state of this kind of laser, programming to calculate the loss difference between two reverse rings and the minimum loss, then we use this program to design a theoretically possible monolithic non-planar ring laser, then we will test two such lasers which can output different wavelengths to check their actual performance, preparing for the actual production of monolithic non-planar ring laser. Key words: monolithic non-planar ring, end-pumped, Jones matrix 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc262924491 第一章 引言 PAGEREF _Toc262924491 \h 5 HYPERLINK \l _Toc262924492 第二章 单块非平面环形腔激光器的结构与理论分析 PAGEREF _Toc262924492 \h 6 HYPERLINK \l _Toc262924493 2.1行波环形腔振荡器的结构与原理 PAGEREF _Toc262924493 \h 6 HYPERLINK \l _Toc262924494 2.2单块非平面环形腔晶体结构及光路分析 PAGEREF _Toc262924494 \h 7 HYPERLINK \l _Toc262924495