《110KV变电站电气二次部分初步设计》-毕业论文.doc

w w 本 科 毕 业 设 计 论文题目 110kv变电站电气二次部分初步设计 学生姓名 学 号 073522008 所属院部 电子与信息工程学院 专 业 电气工程及其自动化 班 级 电气2班 指导教师 2011年5月 摘要 本次设计任务旨在体现对本专业各科知识的掌握程度，同时检验本专业的学习结果。首先根据任务书上所给系统与线路及所有负荷的参数，分析负荷发展趋势。从负荷增长方面阐明了建站的必要性，然后通过对拟建变电站的概括以及出线方向来考虑，并通过对负荷资料的分析，安全，经济及可靠性方面考虑，确定了110kV，35kV，10kV以及站用电的主接线，然后又通过负荷计算及供电范围确定了主变压器台数，容量及型号，同时也确定了站用变压器的容量及型号，最后，根据最大持续工作电流及短路计算的计算结果，做出线路保护，变压器保护，母线保护，防雷保护。从而完成了110kV电气二次部分的设计。 关键词：电力系统，短路电流，继电 ABSTRACT Design the task this time is aim at intensity of mastering of every subject knowledge of this reflecting, and of test this study result. first, analyze the tend of load department according to all parameter of load about system and circuit on task book. It expounds the necessity to this situation from the respect of increasing load. Then through to the generalization of planning to build the transformer substation and the analysis of the load materials, safe, economy and dependability are considered, has confirmed the mainly wiring form of 110kv, 35kv, 10kv. Calculated and supplied power in the range and confirmed TV stations number of the main voltage transformer through load finally, capacity and type, capacity and type of using the voltage transformer stand surely at the same time, finally, the result of calculation of calculating that and short out according to the electric current of largest lasting job, make the circuit to protect, the voltage transformer is protected, the bus bar is protected, prevent the thunder from protecting. Thus finished electric designs of the part two times of 110kv Key Words：Power system；short out in the electric current；relay protection w 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc291967998 1 绪论 1 HYPERLINK \l _Toc291967999 2 变电站的分析与设计 3 HYPERLINK \l _Toc291968000 2.1 变电站的总体分析 3 HYPERLINK \l _Toc291968001 2.2 变电站的负荷分析 4 HYPERLINK \l _Toc291968002 2.2.1 Ⅰ、Ⅱ类负荷分析 5 HYPERLINK \l _Toc29196800