大跨度钢桁架整体提升技术研究及施工仿真分析-建筑与土木工程专业论文.docx

that the spreader the maximum stress is 347.8MPa, the maximum displacement of the spreader is 6mm, which meets the requirements of strength and rigidity. Moreover, the strength and stiffness of the lifting node were checked. It is seen that part region of the joint go into the plastic zone, which can not meet the requirements of the design. Recommended plus two seal plate in the first node of H section steel plate on both sides. Combined with the engineering example, the lifting points’ layout of structure was studied. Comparing with all kinds of lifting point layout, finally the scheme two was chose as the best one. And in view of the additional stress of construction process, the calculation method was proposed. Taking 0.9 as the bar stress ratio control index, the 190 members which exceed the standard were replaced. Key Words：Large-span steel truss；Integral lifting；Simulation analysis；Lifting points’ layout；Additional stress ratio 目 录 摘 要.............................................................................................................................................I Abstract............................................................................................................................................. II HYPERLINK \l _bookmark0 1 绪论.......................................................................................................................................... - 1 - HYPERLINK \l _bookmark1 1.1 大跨度钢结构概念.................................................................................................... - 1 - HYPERLINK \l _bookmark2 1.2 大跨度钢结构种类.................................................................................................... - 1 - HYPERLINK \l _bookmark3 1.3 大跨度钢桁架结构形式........................................................................................... - 3 - HYPERLINK \l _bookmark4 1.4 大跨度钢桁架施工工艺及工程应用..................................................................... - 3 - HYPERLINK \l _bookmark5 1.5