《HY手机前壳注射成型工艺与注射模具设计》-毕业论文（设计）.doc

PAGE 毕业设计说明书（论文）中文摘要 本文主要介绍了手机外壳的塑料模具设计，其材料是ABS+PC。首先是产品的结构分析、设备的选择与校核、模具的设计（模具浇注系统设计、成型零部件的计算与设计、导向脱模机构、温控系统），其采用一模一腔的模具设计工艺。本设计着眼于一次注射成型出塑料制件，叙述了模具的设计方案的分析、零件的选择以及重要部分零部件的设计过程。介绍了模具的工作原理，并且对塑件的成型及塑件的一些性能作了介绍。最后一部分是基于CAE软件介绍产品的模流分析过程。即用Moldflow软件分析了塑件最佳浇口的位置及翘曲流动；具体介绍了填充时间、压力、温度、熔接痕线、气泡等等。 关键词 注塑模 结构分析 模具设计 模流分析过程 毕业设计说明书（论文）外文摘要 Title The ejection forming process analysis and ejection on mold design of the mobile telephone shell product from HY Abstract This paper chiefly introduced the plastic mould design of mobile telephone shell which of the material is ABS and PC. First is the analysis of the product structure ,the selection and checkout of the equipment, mold designing (the selection of the mould’s gating system, the computation and design of the forming parts, the designs of guided ejection structure, and the temperature-adjusting system and so on).This paper adopted the mold design system of one cavities in one mold. And the important point is that it introduced the method analysis of mold design, the selection of parts and the process design of other important parts. Probably gave some introduction about the principle of mold working, parts forming and some capabilities of part at the same time. The last part is the introduction of Moldflow analysis process according CAE. Then use the software of Moldflow to analysis the best gates location and warp,flow; concretely introduce fill time, pressure ,temperature ;weld lines ;air traps and so on. Keywords injection mold structure analysis mould design moldflow analysis process PAGE 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _To前 言 PAGEREF _To\h 1 HYPERLINK \l _To第一章 塑件分析 PAGEREF _To\h 2 HYPERLINK \l _To1.1塑件介绍 PAGEREF _To\h 2 HYPERLINK \l _To1.2产品的工艺分析 PAGEREF _To\h 3 HYPERLINK \l _To第二章 成型工艺的确定与设备的选择 PAGEREF _To\h 4 HYPERLINK \l _To2.1 制件成型工艺的确定 PAGEREF _To\h 4 HYPER