不同配风方式下超临界墙式切圆锅炉燃烧特性的数值-内蒙古电力技术.PDFVIP

内蒙古电力技术 10 INNER MONGOLIA ELECTRIC POWER 2017 年第35 卷第4 期 doi:10.3969/j.issn. 1008-6218.2017.04.002 不同配风方式下超临界墙式切圆锅炉燃烧特性 的数值模拟分析 李应保，王东风 （华北电力大学 河北省发电过程仿真与优化控制工程技术研究中心，河北 保定 071003 ） 摘要：以华能营口电厂600 MW 超临界墙式切圆燃烧锅炉为研究对象，采用计算流体力 学仿真软件对在不同配风方式下锅炉炉膛内温度场和NO 质量浓度进行数值模拟分析。数x 值模拟结果表明：在一、二次风正宝塔式配风方式下，炉内温度分布状况理想，下二次风托粉 效果好，锅炉内燃烧充分且无贴壁燃烧现象；另外，一、二次风正宝塔式配风方式结合燃尽风、 附加风风量的调整，可以有效降低炉内NO 的生成量。以上结果对该类型锅炉运行、设计和x 改造具有指导价值。 关键词：墙式切圆锅炉；配风方式；温度场；氮氧化物；燃烧特性；数值模拟 文献标志码：B 中图分类号：TM621.2 文章编号：1008-6218（2017 ）04-0010-06 Numerical Simulation Analysis of Combustion Characteristics of Supercritical Wall-Tangentially-Fired Boiler Under Different Air Distributions LI Yingbao, WANG Dongfeng （North China Electric Power University, Baoding 071003, China） Abstract ：600 MW supercritical wall-tangentially-fired boiler located in Huaneng Group Yingkou Power Plant was taken as a research object, applied computational fluid dynamics simulation software to simulate and analyze the temperature field and NOx mass concentration in boiler furnace under different air distributions. The simulation results showed that the temperature distribution in the furnace was right, the bottom of second air had good holding powder effect, the combustion was sufficient and the flame was not adherent to furnace when boiler applied positive pagoda air distribution. In addition, when first air and second air positive pagoda air distribution combined with the adjustment of the amount of over-fired air and addit