分级保护式直流限流器的研究-电力系统自动化专业论文.docx

II II Abstract DC system is the power system control, protection, signals and automatic device power, it directly related to the reliability of the power systems security. When the system fault, the traditional time-bound anti-breaker / fuse failure will be removed, but may appear that the fault of the circuit breakers / fuse is not broken and leapfrog moves to DC power of the insurance fuse, power supply disappear, accident Spread rapidly expanding, causing the power system catastrophic damage to the equipment and systems accident. Selective protection can not be achieved. Therefore, the current limit on new programmes or current limit equipment has become an urgent issue. This paper outlines the current limit development of the device, the focus on the superconducting current limiter (SFCL) and solid-state current limiter (SSFCL) the typical topology and the work of these two common principles and current limit for the simulation. And that these current limiting devices in practical application deficiencies. By reading a lot of references and previous studies concluded on the basis of a circuit based on the chopped-BUCK thinking and achieve solid grade protection of the DC current limiting device. Are the main parameters for the detailed calculation. MATLAB simulation software through the use of simulation, experimental prototype built, and test a detailed analysis of the power system. The current limit wave device simulation and test verification are the wave of new short-circuit DC-DC power distribution network to achieve the grade protection. Keywords: Short-Current Fault Superconducting Current Limiter Solid-State Current Limiter Grade Protection Current Control PAGE PAGE IV 目 录 摘要 I HYPERLINK \l _bookmark0 ABSTRACTII 1 绪论 HYPERLINK \l _bookmark1 1.1 限制故障电流的必要性(1) HYPERLINK \l _bookmark2 1.2 断路器的工作特性(2) HYPERLINK \l _bookmark3 1.3 熔断器的工作特性(3) HYPERLINK \l _bookmark4 1.4 直流电力系统分级保护的意义(5) HYPERLINK \l _bookmark5 1.5 直流系统级差配合的重要性(6) HYPERLINK \l _bookm