基于LTCC的LED驱动器研究-材料科学与工程专业论文.docxVIP

万方数据 万方数据 摘要 摘 要 随着 LED(Light Emitting Diode)产业的发展，LED 灯慢慢取代传统光源作为可 携带移动电子设备 LCD（liquid crystal display）显示屏的背光灯，电子设备都向着 大屏幕、小体积的方向发展，要求背光系统的 LED 数量越来越多。作为背光系统 能量来源的 LED 驱动器模块也必须适应电子设备的发展趋势，不断减小体积、厚 度，提高功率密度。 LED 驱动器模块中体积最大，高度最高的元器件是磁性器件。因此，缩小磁 性器件是驱动器模块小型化的关键。传统的磁性器件把线圈绕在磁芯上而成，体 积大、功率密度低。本文采用 LTCC 技术，将磁性器件和电路板进行无源集成，实 现了驱动器模块的小型化。 本论文主要包括以下主要内容：首先根据 LED 灯的特点给出了连接方式和驱 动方案。然后确定驱动电路拓扑结构，设计电路参数，搭建了基板为 PCB 板的驱 动器模块。再介绍了 LTCC 工艺流程，利用理论计算出电感线圈的基本参数，通过 电磁仿真软件优化验证。最后基于 LTCC 工艺线制作出铁氧体材料磁性基板，线圈 内埋在基板中构成电感，在基板表面印刷电路，线路上贴装其它元器件，装配调 试驱动器模块。驱动器模块电气指标均满足设计要求，高度仅为 3mm，达到业界超 高水平，为可携带移动电子设备的小型化，超薄化提供了有力地保证。 关键词：LED 驱动器 LTCC 小型化 I Abstract Abstract With the LED (Light Emitting Diode) industry development, LED lamps slowly replaced the traditional lamps as LCD screen’s backlight of portable mobile electronic devices. Electronic equipment developing towards big screen, small volume and requires more LED amounts of backlighting system. As the energy sources of backlighting system, LED drive module must adapt to the trend of electronic equipment development, continuously to reduce the volume, thickness to increase power density. The highest and the biggest component of LED drive module is magnetic device. Therefore, narrowing the magnetic device is the key point of driver module miniaturization. The traditional magnetic devices are made by encircle the coil on ferrite core, big volume and low power density. This paper uses LTCC technology, will integrate magnetic device and circuit board, and achieve the goal of driver module miniaturization. This paper mainly includes the following main contents: first of all, give connection mode and drive scheme according to the characteristics of LED. Then, determine the topology of driving circuit, design circuit parameters, construct the PCB substrate for drive modules. Introduce LTCC technology process, use the theoretical knowledge to calculate the basic parameters of the inductance coil, use the electromagnetic simulation software to optimize and