一种UPQC直流侧电压控制器的设计方法研究-电力系统保护与控制.PDF

第 38 卷 第 22 期 电力系统保护与控制 Vol.38 No.22 2010 年 11 月 16 日 Power System Protection and Control Nov. 16, 2010 一种 UPQC直流侧电压控制器的设计方法研究 谭智力，朱冬姣 （中国地质大学机电学院，湖北 武汉 430074） 摘要：统一电能质量调节器（UPQC）的直流侧电容电压维持恒定与其和电源的有功功率平衡有关，为获得直流电压闭环控制 模型，将直流电压表示成为电源有功电流的函数是必要的。提出了一种利用 UPQC 小信号模型推导出直流侧电压和电源电流 的线性表达式的方法，据此获得了直流侧电压控制的闭环模型。以此为基础，探讨了直流侧电压控制器的设计方法。利用这 种方法，针对实际的控制策略，计算出控制器的参数。仿真结果显示，采用这种方法设计的直流侧电压控制系统具有较好的 频率特性，获得了较好的直流侧电压，表明这种方法是有效的。 关键词：UPQC；小信号模型；线性模型；控制器设计 Design of voltage controller for UPQC on its DC side TAN Zhi-li，ZHU Dong-jiao （School of Mechanical Electronic Information，China University of Geosciences，Wuhan 430074 ，China ） Abstract ：For UPQC, maintaining its constant DC voltage is related to the active power balance between it and sources ．So，to get a mathematical model of the closed loop controller of DC voltage ，expressing it as a function of the active current of sources is critical ．This paper proposes a method of designing the DC voltage controller by using the small signal model of UPQC ，with which mathematical relationship between DC voltage and the active current of sources is deduced, based on which the mathematical model of closed loop of DC voltage is promoted ．Parameters of the controller are calculated with it. The simulation results show that the DC control system has good frequency characteristic and DC side voltage，which verifies the effectivity． This work is supported by National Natural Science Foundation of China(No. Key words：UPQC ；small signal model；linearized model ；design of controller 中图分类号： TM76 文献标识码：A 文章编号： 1674-3415(2010)22-0190-06 电源电流的线性表达式，获得直流侧电压控制的闭 0 引言