华北H市4万吨每天排水工程设计.docVIP

华北H市4. 0万吨/天排水工程设计 近年来，随着经济飞速发展，人民生活水T不断提高，环境污染也H趋严重。现 拟建一座生活污水处理厂，处理规模为40,000n?/d,设计出水水质耍求达到《城镇污 水处理厂污染物排放标准》GB18918-2002 一级A标准。 木设计主要包括W大部分： 第一部分：华北H市排水管网初步设计。 该城市采用分流制排水系统，即雨水和污水通过不同系统排除，然后，污水汇入 城市污水处理厂集中处理，雨水汇入雨水管网收集盾直接排入河流。 第二部分：城市污水处理厂的设计 根据管网段计算得到污水为H处理量约为3.3万吨，考虑到远期取4万吨/天。木 次设计要求最后岀水水质要达到一级A标准，所以在确定工艺前参考了一些实际案 例，总结案例经验，通过比较优缺点，结合经济比较，在A2O工艺和三沟式氧化沟 工艺之间选择，最后选择了 A2O工艺，这组工艺结合了高效，稳定，经济合理，自 控程度高，运行管理方便等优点，并广泛运用于现在很多污水处理站。 关键词雨污分流；A2O工艺；三沟式氧化沟工艺 INTRODUCTION Abstract Nowadays，environmental pollution is more serious with the development of Economics. The people’s living is improved.However,the environmental pollution is improved too. Now we are plan to build a sewage treatment plant in the city. Treatment scale of Sewage is 40000m3/d. The effluent quality complying to the GB18918-2002 1A discharge standard. The report has two parts. Part One:The primary design of the municipal sewage system . This city uses separate sewage system which the sewer and storm water uses different discharge systems.Then.sewer are centralized together to the sewage treatment plant.The storm water will be discharged into river. Part Two:Design of Municipal Sewage Treatment Plant The design of the municipal treatment plant considered treatment rules based on pipe segment is 33,000 tons / day.Considered forward it will be 40,000 tons/day.The design requirements of the final effluent quality to achieve a 1A standard.Before we design the plant,we reference to some practical cases and summarize case experience.Than we chose the A2O technology by compared the economic benefits of A2O technology and Triple Ditch OD Process. A2O technology combined with the advantages of high efficiency， stability，reasonable economy，high degree of automation，convenient operation and management，etc. It is extensive used in most of sewage treatment plant. Keywords ; A2O technology; Triple Ditch OD Process 1绪论 1.1引言 水是现代生活屮必不可缺的一样资源。随着城市规模不断扩大，人口不断增加， 水体污染H益严重。建立一个完善的城市污水排放体系，对一座现代化城市来说必不 可少。 建立一个完善的城帘污水排放系统需要结合木城