照相手机CCM模组SMIA标准.ppt

五、照相手機CCM模組SMIA標準 SMIA (Standard Mobile Imaging Architecture) Specifications of camera modules for provision of mobile device manufacturers’ convenience for mounting of a module in mobile phones, by functionally or optically standardizing operation performance of camera modules SMIA is proposed by Nokia and ST-Microelectronics on 1st.07.2004. It is possible that SMIA will be part standard of MIPI(Mobile lndustry Processor lnterface) SMIA Overview Making a Raw Bayer Sensor Module easier to integrate in a system to create a ‘camera’. Creating a standard applicable to a wide range of sensor resolutions and frame-rates, to proliferate a family of ‘like’ modules with known upgrade paths. Improving design and verification cycles. Enabling true second sourcing of sensor modules. Interface of SMIA standard □CCP2 (Compact Camera Port 2) CCP2 is a 4-wrie Low EMI SubLVDS data link. The maximum data rate is 650 Mbps. This is sufficient to support readout of an image of up to 2 Mega Pixels in a 1/30th of a second using the RAW8 CCP2 mode. It fully defines the sensor modules electrical, control and image data interfaces. □CCI (Camera Control Interface) The 2-wire camera control interface is I2C compatible. The maximum data rare is 400 kHz. Low frequency external clock (6-27MHz) Chip enable signal - XSHUTDOWN Analogue Power Digital Power SMIA 六大範圍 1.The functional specification: frame and field formats, register maps for set-up and control and has three profiles that helps easy video usability with high resolution sensors. 2.The electrical interface: the physical layer (voltage levels, pin-count, timing), data rate (up to 650Mb/sec), EMI (electro-magnetic interference) performance, and output image format. 3.The mechanical interface proposes a family of set of modules that provide mechanical outlines specifically designed for volume manufacturing. 4.The characterization chapter provides for optical-performance metrics and sensor noise stan