GARRI-4电站2号汽轮机轴瓦检修方案1.doc

精品文档 可编辑 Garri 4 Power Plant Turbine 2 Bearing Maintenance Program and Schedule GARRI-4电站2#汽轮机轴瓦检修方案和进度计划书 Maintenance Items 检修项目 No. 序号 Inspecting, Measuring and Adjusting Items 检查、测量、调整项目 1 Inspect turning gear. 检查盘车装置 2 Inspect Bear 1-4, turning gear oil inlet orifice, and make proper precautions. 检查1#~4#轴瓦、盘车进油孔，并做好防护措施 3 Visually inspect if the bearing alloy is intact or not, inspect, measure and adjust the contact of lower bearing pad block and the contacting between bearing and shaft, check the interference between bearings and regulate parameters to ensure that they would meet the erection standard of manufacturer. 检查外观、巴氏合金是否完好，检查、测量、调整轴瓦下瓦垫铁的接触情况，轴瓦与轴接触情况，测量轴瓦间隙紧力，调整各数值达到汽轮机厂家安装要求 4 Check the contacting of Bearing 34 anchor bolts and lower bearing pad block and make adjustment if necessary. Measure the clearance and interference, check and adjust the contact between generator shaft and lower bearing. 检查3#、4#轴瓦地脚螺栓、轴瓦下瓦垫铁的接触情况，必要时调整。测量间隙及紧力，检查、调整发电机轴与下瓦接触情况 5 Measure shaft journal swing degree, ovality and bending degree. 测量轴颈晃度、椭圆度和弯曲度 6 Inspect, measure and adjust coupling rotor alignment. 检查、测量、调整联轴器转子中心 7 Inspect, measure and adjust all bearing oil baffle clearance. 检查、测量、调整各轴瓦油挡间隙 8 Assemble pipes, instruments and electrical system of bearing and bearing housing. 恢复轴瓦、轴承箱管道、仪表、电气系统。 9 Trial run the turbine and detect the vibration. 试运汽轮机，检测汽轮机振动情况 Manning: 1 supervisor, 6 technicians, 3 others. 检修组织：检修负责人1人，检修技术员、技工6名，其他人员3人。 Quality Objectives: Maintenance quality shall meet the manufacturer erection quality requirement. Through bearing and rotor alignment inspections, possible causes of high vibration which refer to improper bearing interference or rotor alignment shall be eliminated. 质量目标：检修质量符合汽轮机厂家安装质量要求，通过对轴瓦及转子中心的检查，并消除因为轴瓦间隙紧力不当或者转子中心不正所引起的振动。 Preparations for Maintenance 检修准备 Such relative unit technical materials as drawings and instructions shall be prepared and complete. (provided by owner) 有关机组的图纸、说明书等技术资料准备齐全。（业主准备） Special tools require