论文隔声罩设计--终结.doc

青岛理工大学本科毕业设计（论文）说明书 PAGE 1 摘要 噪声污染日益成为影响人们身体健康和生活质量的严重问题，尤其是厂矿企业飞速发展，伴随着大型机器、设备运作的剧增，厂区噪声污染对工厂工人和工厂周边居民正常工作、生活、学习、休息环境的干扰程度和范围也随之加剧。控制噪声成为日益重要的问题。 隔声罩是将噪声源置于隔声罩内，隔断其噪声向罩外传播。它既可隔离设备的高噪声，又可以作为高噪声车间的控制室，减少噪声对人体的危害。使用隔声罩是降低各类设备噪声干扰的有效措施，广泛应用于压缩机、鼓风机、电机、电炉、球磨机、粉碎机、冲床、水泵等设备的噪声治理。本文介绍了隔声罩的用途，类型及本设计的隔声罩的特点，阐述了煤气压缩机产生噪声的特点，及隔声罩的隔声原理。该隔声罩应用于大型煤气压缩机上，隔声罩的种类多种多样,采用可拆卸式支撑架，然后在支撑架中嵌插隔声板材。设有进风口，排风口，在进风口处装有D型阻性折板式消声器，在排风口处装有4台离心式风机，用于排风降温。同时隔声罩内装有温度传感器及一氧化碳浓度传感器理论隔声量为20dB，隔声罩的风机与传感器联动，通过PLC控制来实现隔声罩的智能控制。温度或一氧化碳浓度达到或超过设定的临界值时，与传感器连接的PLC控制部分会控制发出指令让风机启动排风，以便使空气温度或一氧化碳浓度降低，当温度或浓度值低于临界值时，风机接到来自于PLC的命令，停止排风。因此该隔声罩是具有智能控制功能。 关键词：隔声罩 煤气压缩机 噪声控制 隔声量 智能控制 PLC Abstract Noise pollution is increasingly becoming affect peoples health and quality of life of the serious problems, In particular the rapid development of factories and mines enterprises, accompanied by a large-scale machinery, equipment operation of the rapid increase in factory noise pollution on factory workers and factories nearby residents to work, live, study, rest of the disturbance of the environment and also will become worse. Noise control becomes increasingly important issue. Acoustic enclosure is the equipment which put the source of noise into acoustic enclosure, cut off their noise to cover the spread. It not only can isolate the noisy of equipment, but also as a noisy workshop of the control room, to reduce noise on the human body harm. The use of acoustic enclosures is to reduce equipment noise and effective measures, widely used in air compressors, blowers, motors, electric furnace, ball mill, shredders, presses, pumps and other equipment of the noise Control. In this paper, we introduced the use of acoustic enclosures, and this type of acoustic enclosures design features and gas compressor on the characteristics of a noise, the noise and acoustic enclosures principle. The acoustic enclosure is used for large gas compressor, using removable, and then MOUNTING embedded in the plate inserted. Into a tuyere,