解读我国钢筋混凝土抗震设计新规范（interpretation of new c时odes for seismic design of reinforced concrete in china）.docVIP

解读我国钢筋混凝土抗震设计新规范（Interpretation of new codes for seismic design of reinforced concrete in China） Interpretation of new codes for seismic design of reinforced concrete in China Key words: Code for seismic design of buildings, GB50011-2001, code for design of concrete structures, GB 50010-2002, technical specification for concrete structures of tall buildings, JGJ3-2002 1 Determination of seismic force in structural design Feasibility of 1.1 low seismic force By 1980s, all specifications for the design of a recognition of the fact that in the earthquake, the structure in real failure, there is a large plastic deformation (ductility), the structure may reach or close to the yielding state in a smaller earthquake; in a large earthquake, some parts of the structure will enter the non elastic deformation after yielding, and with the increase of the force of the earthquake, the structure in elastic-plastic deformation area increased, yield into advanced parts of elastic-plastic deformation also increases. The structure converts energy from this earthquake to heat energy by dissipating more seismic energy. For the design of earthquake force ductility joint rule, we can understand the relationship between the seismic force and structure: on the one hand the low seismic design structure, seismic energy dissipated by deformation more inelastic more inelastic deformation; on the other hand, the greater the structure, reduction of stiffness damping more serious. Cycle ratio increased, structure seismic design force increase more, the total seismic force of the structure has also been reduced more. This allows us to take a seismic response below the fortification intensity as a design tool in the design process without reducing the vertical bearing capacity of the structure and ensuring the ductility of the structure. Conversely, if the design of earthquake force based on the lower part of the structure yield, reduce the bearing capacity of horizontal and vertical yield under the