《基于FPGA的远程定位技术研究》-毕业论文（设计）.doc

PAGE 河北工业大学城市学院2014届本科毕业设计说明书 毕业设计（论文）中文摘要 题 目：基于FPGA的远程定位技术研究 摘要： GPS（全球卫星定位系统）可以实现一种非常稳定的有效的汽车定位方法，利用 GSM（全球移动通信系统）技术将GPS接收到的定位消息迅速的发送到接收终端。把这两种技术组合在一起形成的汽车监控导航系统，为解决相关问题找到了不错的方法，在汽车导航控制系统的过程中发挥着重要作用。 基于FPGA 的GPS/GSM汽车监控系统，采用FPGA的嵌入式微处理器核当作数据处理和控制核心，用来完成对 GPS 数据、短消息等数据的处理以及对车载台各个模块的控制功能。本设计采用sim908模块，它将GPS/GSM模块集成在一起，这样的设计明显减少了开发GPS功能应用的成本和时间。本次设计通过在nios II的SOPC builder中构建出系统的软核，在quartus里面搭建好系统的硬件电路图。 在NIOS II IDE软件中编写程序。该系统预期的目标是将GPS模块接受到的定位信息通过串口发送回来，再将定位信息解析后，通过GSM模块发送到用户手机。目前，系统可以实现GPS定位信息的接收和显示。 关键词： FPGA ?GPS? GSM 毕业设计说明书 毕业设计（论文）外文摘要 Title ? Remote positioning technology research based on FPGA? ? Abstract: GPS (global positioning system) can realize a very stable and efficient motor positioning method. Using GSM (global system for mobile communications) technology can rapidly transmit the positioning data information that received by GPS to the receiving terminal.A combination of GPS/GSM vehicle monitoring system,is a good solution to solve the above problem .this technology is playing a more and more important role in the process of car navigation control system. GPS/GSM vehicle monitoring system on-board based on FPGA , Using embedded microprocessor core of FPGA as information processing and the control core, to complete the GPS data and short message data processing and control of the vehicle platform module . Using sim908 module,which can integrate GPS,GSM module together. This design can reduce the cost and time of GPS application.The core of the system is designed in the nios II SOPC builder And the quartus can build the hardware circuit .The program is written in the NIOS II IDE software.The system is expected to transmit the positioning information received by GPS module through a serial port. Then analyzing the positioning information and sending to the user’phone through GSM module . At present, the system can only accept and display the GPS positioning information . Keywords： FPGA ?GPS? GSM 目录 TOC \