连续铸造复合轧辊辊芯预热的数值模拟-JournalofNortheastern.PDF

第2 8 卷第10期 东 北 大 学 学 报 ( 自 然 科 学 版 ) Vol12 8, No. 10 2 00 7 年 10 月 Journal of Nort heastern U n vers ty( N atural Sc ence) Oct. 2 0 0 7 冯明杰, 王恩刚, 王俊刚, 赫冀成 ( , 110004) : , , , , # , , , ; ; , , , # : ; ; ; : T F 777 . 7 : A : 1005- 3026( 2007) 10- 140 1- 05 Numerical Simulation of Preheating Core of Composite Roll for Continuous Casting FEN G M ing-j ie, WAN G En-gang, WANG Jun-gang, HE Ji-cheng ( K ey L aboratory of Nat onal Educat on M n stry for Electr omag net c P rocess ng of M ater als, N ortheastern U n vers ty, Shenyang 110004 , Ch na. Correspondent : WA NG En- gang , E- ma l: egw ang @ 263. net) Abstract: Some mathemat cal models were developed for preheat ng t he core of compos t e roll for cont nuous cast ng , t hen the effects of t he cast ng speed and ceram c heat- nsulat on tube on t he d st r but on of preheat ng temperature w ere nvest gated by numer cal s mulat on . T he result s nd cat ed t hat the max mum temperature d ff erence bet ween roll core. s surf ace and cent er appears w hen the core s draw n up t o equ valent to t he bot tom of co l, and t he center t emperat ure s h gher than surface. s w hen t goes off to d stance from t he pos t on because of t he heat rad at on of core. s surf ace. T he h gh cast ng speed s d sadvantageous to roll core reheat ng. T he ceram c heat- nsulat on t ube w ll benef t t he heat preservat on of core. s surface w hen the cast ng speed s low but t s not so obv ou s at h gh cast ng speed. Key words: compos te roll; core reheat ng; temperature d st r but on; numer cal s m ulat on