单滚筒底盘测功机寄生摩擦阻力测量方法研究-中国测试.PDF

第42卷第6期 中国测试 Vol.42 No.6 2016年6月 CHINA MEASUREMENT TEST June，2016 doi院10.11857/j.issn.1674-5124.2016.06.002 单滚筒底盘测功机寄生摩擦阻力测量方法研究 龚志远袁 刘志雄袁 欧阳爱国袁 陈齐平 （华东交通大学，江西 南昌 330013） 摘 要院针对单滚筒底盘测功机寄生摩擦阻力的获取袁在不同加速度下对测功机进行加载滑行袁对测功机的基础惯量 进行标定袁然后采用空载滑行法袁根据基础惯量尧速度区间与滑行时间得到各测量速度点的寄生阻力值袁再将其拟合 成二次曲线遥 最后袁采用等速法加载不同惯量值对曲线进行验证袁结果表明院采用此方法所得出的测功机寄生阻力计 算模型满足试验要求袁具有较高的准确度遥 基础惯量 关键词院单滚筒；底盘测功机；寄生阻力； 文献标志码院A 文章编号院1674-5124渊2016冤06-0005-04 Study on the measurement method of single drum chassis dynamometer parasitic friction resistance GONG Zhiyuan，LIU Zhixiong，OUYANG Aiguo，CHEN Qiping （East China Jiaotong University，Nanchang 330013，China） Abstract: In order to obtain the parasitic friction resistance of single drum chassis dynamometers， loaded sliding tests for dynamometer under different acceleration conditions was conducted and the basic inertia of the dynamometer was calibrated. Then，no-load sliding method was used to acquire the parasitic resistance at each measurement speed point according to the basic inertia，velocity section and sliding time. After that，the parasitic resistance values were fitted into a quadratic curve. Finally，the curve was verified by loading different inertia values at a constant speed. The results show that the calculation model obtained for dynamometer parasitic resistance obtained from this method can satisfy the testing requirements and has high accuracy. Keywords: single drum；chassis dynamometer；parasitic resistance；base inertia [1]