控制阀结构与维护.pptVIP

Comparison of the Step Response test which shows the overshooting due to high positioner gain and the result (red line) after the gain has been properly tune. Similar the Valve Signature graph, the results can be overlapped for comparison. Comparison between the good Dynamic Error Band graph during commission and the one due to galled bearing which show the hunting at the closing end the valve plug galled against the seat. Similarly, the results can be overplayed for comparison. Besides the Performance Diagnostics (on-line), there are many other tools we can use to detect problems that might occur when the valve in service. One of them is the alert monitoring where any of the alert can be set to prompt the operator if the condition is not met. A more versatile tool is the “Event Messenger” where the alerts can be re-rout via email or SMS message. This will free the operator from the computer station as well as enable the engineer in charge to be aware of the critical alerts… hence Showing the important of good control on the overall loop , what will be the impact of a poorly control final control element VS a final control element that is with Digital Valve Controller (DVC), Since customer invested a lot on System to have good control capabilities and also on transmitter which is doing 0.04% control , so it will be justifiaable if valve control can be improve, Highlight the graph on the right hand to show improvement when using Smart positioner. This is the valve Signature which shows the valve information when the valve at it optimum performance, that is during commissioning stage and the Valve Signature for the same valve but during the schedule shutdown. Note that the valve travel is elongated which cause by the damage to the seat. The results can be overlapped for better visualization. 1 82 Overlay Dynamic Error Band shows valve hunting due to galled bearing 与标准曲线比较以发现问题 4 83 需要在线监控阀门性能 84 在线诊断 摩擦力/力矩 死区大小 滞