三肢钢管混凝土格构柱滞回性能研究结构工程专业论文.docxVIP

三肢钢管混凝土格构柱滞回性能研究Study 三肢钢管混凝土格构柱滞回性能研究 Study on Hysteretic Behavior of Three··Legged Concrete·-Filled Steel Tubular Latticed Columns Abstract Concrete-filled steel mbular rCFST)1atticed members have a large cross—sectional moment of inertia due to the main load-bearing limbs being away from the centroidai axis． Compared“t11 single CFST members under the same conditions，CFST latticed members have a lighter weight，a better axial stability and a larger flexural stiffness．In practical engineering，CFST latticed members are adopted when the member has the large load eccentricity ratio and／or slendemess ratio，such as column of industrial plants，trestle column， arch rib of arch bridge，etc．Currently，the static performance of CFST latticed columns and hysteretie behavior of two·legged and four-legged CFST latticed columns has been studied by the researchers；however，there is no literature about the seismic performance of three-legged CFST latticed columns．To promote the application of three-legged CFST latticed columns in the earthquake area，it is necessary to comprehensively investigate the hysteretic behavior of three—legged CFST columns． The hysteretic performance of three—legged CFST latticed columns were experimentally studied in this paper and the calculating method for horizontal beating capacity of the tested specimens was also discussed．The main contents ale as following： (1)The related studies available in the literature，including seismic performance of single CFST columns，static behavior of CFST latticed columns and seismic performance of CFST latticed columns，were reviewed． (2)Tests on six three—legged CFST latticed colunms and two corresponding three—legged steel latticed columns under cyclic loading were carded out to investigate the effect of diameter·-to·-thickness ratio of column limbs and axial compressive load ratio of the latticed column on the load versus displacement hysteretic and skeleton curves，initial stiffness， energy dissipation and displacement duc