超级电容器串并联变换技术研究电机与电器专业论文.docxVIP

超级电容器串并联变换技术研究Research 超级电容器串并联变换技术研究 Research on Series and Parallel Connections Change Over Technology of Supercapacitor Abstract Supercapacitor has a very broad application in hybrid car starting and accelerating system and high power pulse power system because of large capacity，high power density， long circle—life in charge and discharge and SO on，but the disadvantage of low energy density seriously restricts development．of the supercapacitor．The supercapacitor will stop discharge when its voltage reaches the half ofthe nominal voltage in the energy storage applications and this will leave the supercapacitor energy in the idle state．In this paper，to solve this problems and trying to reduce the depth of discharge of supercapacitor，the research on series and parallel change over technology of supercapacitor is carried out． In this paper，supercapacitor equivalent circuit model was established firstly，and the supercapacitor series and parallel structure was designed．And then the super capacitor charging and discharging methods were analyzed，and based this，the methods of series and parallel change over was analyzed and the system control strategy was made on the basis of the design method and the amount of voltage and current as the reference of series and parallel change over．And the halGbfidge bi-directional converter topology was analyzed and choosed，and then the relationship between input and output transformer ratio and the efficiency of the converter were analyzed，and finally determine the system input and output transformer ratio limit within 3． Due to the introduction of the series and parallel change over technology of supercapacitor，the input voltage of bidirectional half bridge Buck-Boost circuit step mutations Occur in the Boost mode．However separate feedback control is delay control system，and Can not make the load side voltage fluctuation when then series and parallel change to meet the system requirements．This paper adopt the compound control，the fe