（荐）基于MATLAB的过程控制系统仿真研究毕业设计论文［精选整理］.doc

（荐）基于MATLAB的过程控制系统仿真研究毕业设计论文［精选整理］ 毕业设计论文 基于MATLAB的过程控制系统仿真研究 摘 要 水箱和换热器是过程控制中的典型对象，本设计主要以水箱液位控制系统和换热器温度控制系统为例，通过建立数学模型，确定对象的传递函数。利用Matlab的Simulink软件包对系统进行了仿真研究，并对仿真结果进行了深入的分析。 在水箱液位控制系统中，通过建立数学模型以及实验中对实验数据的分析，分别确定了单容、双容、三容水箱对象的传递函数。在simulink软件包中建立了各系统的仿真模型。通过对仿真曲线的研究，分析了控制器参数对系统过渡过程的影响。 在换热器温度控制系统中，根据自动控制系统工艺过程，利用降阶法确定了对象的传递函数。在软件包Simulink中搭建了单回路、串级、前馈—反馈控制系统模型，分别采用常规的PID、实际PID和Smith预估器对系统进行了仿真研究，通过仿真曲线的比较，分析了各种控制系统的特点。 关键词:过程控制;MATLAB;仿真;水箱;换热器 Simulation and Research of Process Contro1 System Based on MATLAB Abstract Water tank and Heat exchanger are typical object in the process control in the design,The control system of tank level and heat interchange is used as an example.The transfer function object is defined by setting up the mathematical model.I carry on simulation research on the system by using Matlab’s simulink simulation.and deeply analyze the result of the simulation. In the system, which control the level of the tank. The transfer function of a single-tank, double-tank, three-tank is defined by setting up mathematical model and analyzing date. Simulation model of all system set up simulink simulation. The effect that controller parameter composes on the system is analyzed through the research on the simulation cuvers. In the control system of heat inter change. The design uses reduction method and defines the transfer function of the object.according to the technical process in the automatic system.The control system model of single loop, cascade, feed forward-feedback is established. Simulation research on there system is carried on through using conventional PID, the actual PID and Smith predictor , While the characteristics those control system are compared. Key words: Process Control; Matlab; Simulation; Water tanks; Heat exchanger 目 录 摘 要 ........................................................................................................................................II Abstract ...............................................