（外文电子版资料）X-09 Type 1F (High Security Electronic Lock) Operating Instructions.pdfVIP

OPERATING INSTRUCTIONS X-09TM Type 1F HIGH SECURITY ELECTRONIC LOCK TABLE OF CONTENTS INTRODUCTION 1 Lock On Back Cover 1 DIALING THE X-092 Dialing Methods 2 To Power the Lock 2 Dialing A Combination 2 OPEN AND CLOSE THE X-09 (FACTORY COMBINATION) 4 To Open the Lock (Using the Factory Combination) 4 To Close the Lock 4 X-09 LOCK SETUP 5 Set Operating Mode and Change Combinations 5 If You Lock the Change Key in the Safe 8 USING THE X-09 9 Single Combination Mode 9 Dual Combination Mode 9 Supervisory/Subordinate Mode 10 Correct Method of Closing/Relocking Container 11 AUDIT FEATURES OF THE LOCK 12 To Check the Number of Successful Openings 12 To Check the Number of Unsuccessful Attempts 12 GUIDE TO SYMBOLS 13 For Technical Support Call: 1-800-950-4744 INTRODUCTION The X-09 uses sophisticated computer security and makes dialing much easier than that of traditional combination locks. The microprocessor in the lock recognizes a number as part of a combination when you change dialing direction. (See the section on Dialing the X-09.) Note: The lock is shipped preset to operate in the Single Combination Mode with a Default Factory Combination of 50-25-50. LOCK ON BACK COVER The Lock On Back Cover (LOBC) feature provides a locking mechanism that locks the back cover in place after installation. The design is such that the back cover cannot be removed without visible damage unless the combination is known, regardless of whether the lock is locked or unlocked. Note: Because of the LOBC feature, it is not an easy task to remove the back cover to read t