高温钛合金Ti60粉末制备和表征.pdfVIP

24 1 Vol.24 No.1 2 0 1 0 2 CHINESE JOURNAL OF MATERIALS RESEARCH February 2 0 1 0 Ti–60 ∗ ( 110016) Nd Ti–60 , , 100×10−6 ; (d50 ) 100 μm, , Æ; , ; , ; , ; Nd , Nd ; α Æ, 700 , 850 , , , Ti–60 , , , , α TG146 1005-3093(2010)01-0010-07 Preparation and Characterization of High Temperature Titanium Alloy Ti–60 Powders LI Shaoqiang LIU Jianrong WANG Qingjiang∗∗ YAN Wei LI Yulan YANG Rui (Institute of Metal Research, Chinese Academy of Sciences, Shenyang 110016) * Supported by National High–Tech Research and Development Program of China No.2007AA03A224. Manuscript received June 12, 2009; in revised form September 16, 2009. ** To whom correspondence should be addressed, Tel:(024 E–mail: qjwang@imr.ac.cn ABSTRACT The high temperature titanium alloy Ti–60 powder was prepared by Electrode Induction Melting Gas Atomization (EIGA) method. The variation in chemistry between nominal composition and powder was minimal and the increment of oxygen during gas atomization was less than 100×10−6 , which insured the alloy composition and purity of the powder. The powder size distribution followed Gaussian distribution and the medium diameter (d50 ) was about 100 μm, which was decreased with the increasing of argon gas pressure during atomization process. The powder was nearly spherical and some powder particles were irregular. Some powders were hollow and the percentage of the hollow powder increased with the increase of powder diameter. The powder surface showed an obvious characteristic of solidification