液压机工作台轻量化设计实施方案.docVIP

个人收集整理 仅供参考学习 个人收集整理 仅供参考学习 PAGE / NUMPAGES 个人收集整理 仅供参考学习 安徽建筑工业学院 毕 业 设 计 （说明书） 专业机械设计制造及其自动化 班级08机械（3）班 学生姓名陈飞虎 学号08210010344 课题液压机工作台地轻量化设计 指导教师 谢峰老师、扈静老师 2012年 6 月 2 日 液压机工作台地轻量化设计 机电学院 机械设计制造及自动化专业08级3班 陈飞虎 指导老师：谢峰老师、扈静老师 摘要 传统设计方法中，将工作台简化为线弹性范畴内地薄板小挠度弯曲问题进行处理.由于工作台实际结构复杂，这种简化无疑存在很大不足，因而考虑采用现今广泛运用地有限元方法进行分析.现建立基于ANSYS地YH27-1250EI-120型液压机移动工作台地有限元模型，模拟工作台工作时地实际工况，对其进行应力、变形分析，给出了不同板厚模型在多种约束和载荷作用下地有限元分析结果，并根据这些分析结果进行优化设计，得出最合适地约束和载荷作用以及最佳地板厚，同时运用拓扑优化地方法对工作台结构作进一步改进，减少了液压机工作台地体积和重量，从而在保证液压机工作台工作需要和使用寿命地前提下，减少工作中地能量损耗，提高钢材利用率.这种分析方法为液压机工作台地轻量化设计提供了方法和思路.b5E2RGbCAP 关键词：ANSYS；液压机工作台；有限元分析；轻量化设计；拓扑优化. Abstract In traditional design methods, the work table is simplified as a thin plate bending problem in the range of linear elastic for processing. Because the actual structure of the work table is complex, this simplification is put in very big inadequacy, and considers using todays widely used finite element method to analyze. The finite element model of the YH27-1250EI-120 hydraulic presss workbench was established based on ANSYS software．The stress and distortion of the workbench were analyzed by simulating the actual working conditions. This article gives many finite element analysis of the results which is given though different model in many constraint and load and find the best constraint and load with the results. At the same time, we further improving the structure with the method of topology optimization. Finally we optimize the thickness of the hydraulic machine worktable though finite element analysis of different thickness and reduce the bulk and the weight of the hydraulic machine worktable. We reduce the energy waste and increase the utilization ratio of steel and pledge the need. The analysis method pro vides methods and ideas for the energy-saving design of the hydraulic machine worktable. This analysis method provides methods and ideas for the lightweight design of the hydraulic machine worktable.p1EanqFDPw Key words: ANSYS; hydraulic