MSS SP25-2018 阀门、管件、法兰和管接头的标准标记方法.pdf

ANSI/MSS SP-25-2018 Standard Marking System for Valves，Fittings，Flanges, and Unions Standard Practice Developed and Approved by the Manufacturers Standardization Society of the Valve and Fittings Industry, Inc. 127 Park Street， NE Vienna, Virginia 22180-4602 Phone: (703) 281-6613 Fax: (703) 281-6671 E-mail: standards@ MSS S T A N D A R D PRACTI CE SP-25 This MSS Standard Practice was developed under the consensus of the MSS Technical Committee 302 and the MSS Coordinating Committee. In addition, this Standard Practice was approved by an ANSI/MSS Consensus Committee and ANSI as a revised American National Standard. The content of this Standard Practice is the resulting efforts of competent and experienced volunteers to provide an effective, clear, and non-exclusive standard that will benefit the industry as a whole. This MSS Standard Practice describes minimal requirements and is intended as a basis for common practice by the manufacturer, the user, and the general public. The existence of an MSS Standard Practice does not in itself preclude the manufacture, sale, or use of products not conforming to the Standard Practice. Mandatory conformance to this Standard Practice is established only by reference in other documents such as a code, specification, sales contract, or public law, as applicable. MSS has no power, nor does it undertake, to enforce or certify compliance with this document. Any certification or other statement of compliance with the requirements of this Standard Practice shall not be attributable to MSS and is solely the responsibility