基于预测控制的锌空燃料电池极片生产线控制系统研究-机械工程专业论文.docxVIP

基于预测控制的锌空燃料电池极片生产线控制系统研究 RESEARCH ON CONTROL SYSTEM OF ZINC-AIR BATTERY POLE MANUFACTUNG LINE BASED ON PREDICTIVE CONTROL ABSTRACT Zinc-air battery, as new energy resource, has attained more and more attention in the world, which is efficient, non-polluting and recyclable. It is being researched by many domestic and foreign scholars and experts. Zinc-air batteries electrode is a very fluid set of network structure, therefore, traditional manufacturing methods for electrode can not meet the requirement of continuous production. The research of dry-embedded method for zinc-air battery has great significance for the universal application. This paper had researched the control system of the dry-embedded manufacturing line，including the following contents： First, the producing process and the specific structure of manufacturing line had been analyzed, thus the requirement of line had been obtained. In accordance with the different control object, the control system of line was divided into two parts: the motion control and the thickness control. The control strategy of all had been studied in this paper. Second, the control strategy of synchronous and servo system had been studied. The motion system of manufacturing line had been established, which is composed of motion control card and three servo-motors. According to the technical requirements, the hardware of the system had been defined. Then the servo-motor control mode and parameter had been set, and the communication between the control card and servo drive had been build. Third, the dynamic link library of general motion control card, which is based on PID, had been complied in Visual C++, so that the motion control system can achieve precise synchronization movement; and then the control system had been designed in the environment of LabVIEW, which calls the dynamic link library to achieve multi-axis simultaneous control and real-time condition monitor. Fourth，the principle of the thickness control system had bee