DS4000在AIX环境的应用.pptVIP

DS4000在AIX环境的应用 DS4000 Storage Manager v9.1 Supported controllers With 6.1 firmware DS4500, DS4400, DS4300 Turbo With older firmware DS4500, DS4400, DS4300 Turbo, DS4300, DS4100, and FAStT200 Key new features with 6.1 firmware Enhanced Remote Mirroring Performance improvements Microsoft VDS/VSS support (Part of Maintenance Release) RAS improvements Additional Enhancements / Features Screen Shots of Client Enhanced Remote Mirroring Global Copy – asynchronous mirror Global Mirror – asynchronous mirror with consistency group Metro Mirror – synchronous mirror AIX software requirements AIX Hardware requirements AIX Version requirements AIX Version requirements AIX Version requirements AIX restriction Direct-attach configurations are restricted to single-initiator configurations only. Only one connection to each FAStT mini-hub is allowed. Single HBA configurations are allowed, but each single HBA configuration requires that both controllers in the FAStT be connected to a switch, and within the same SAN zone as the HBA. Single-switch configurations are allowed, but each HBA and FAStT controller combination must be in a separate SAN zone. All volumes that are configured for AIX must be mapped to an AIX host group. Connecting and configuring to volumes in the default host group is not allowed. Other storage devices, such as tape devices or other disk storage, must be connected through separate HBAs and SAN zones. Booting from a FAStT device is supported only on AIX 5.1 and 5.2. When you boot from a FAStT device, both paths to the boot device must be up and operational. Path failover is not supported during the AIX boot process. Once the AIX host has booted, failover operates normally. FAStT600,900 dose not support FAStT boot. SMclient Software Installation - AIX Create the /cdrom mount point: # mkdir /cdrom Insert the installation CD and mount the filesystem, for example: # mount -v cdrfs -o ro /dev/cd0 /cdrom Install the SMclient software package, for example: # instal