基于Arduino的温湿度系统设计-精品.docVIP

摘 要 Arduino是比较常用于智能控制的芯片，在智能仪器、工业检测和控制、机电一体等方面应用广泛。使用Arduino可以实现温湿度全程的监测与控制，而且Arduino控制器的使用还具有易于学习掌握，性价比高等优点。 基于Arduino的温湿度控制系统采用一个含有已校准数字信号输出的DHT11传感器来收集环境中的温湿度数据。经过Arduino进行数据处理，再将处理的结果通过LCD显示器进行显示。当环境中的参数达到预先设定的临界值时，报警系统中的无源蜂鸣器就会自动鸣响报警。 采用Arduino设计的温湿度控制系统，可以精确的反应环境的温度以及湿度的变化情况。完成升温、降温等一列智能控制行为。在一定的温度波动范围内保持恒温状态。将这样智能系统应用到现代温室种植当中，可以为农作物的生长提供较为适宜的生长环境。对于一些特殊的农业生产诸如大棚种植和花卉种植等，必须使用温湿度装置对其进行监控使其保持恒定环境。本系统可以及时、精确的反映和控制环境中的温湿度的变化。 关键词： Arduino；DHT11；传感器；液晶显示器；温湿度； ABSTRACT Arduino is relatively commonly used in the control chip, smart instrumentation, industrial inspection control; mechatronics achieved impressive results has been widely applied.also a lot of its strength as the temperature and humidity control system. Able to achieve automatic control of temperature and humidity throughout Arduino, the Arduino is easy to learn and master the high cost-effective. This paper designs a temperature and humidity control system based on Arduino,,the system uses a containing composite sensor DHT11 digital temperature and humidity calibration of digital signal output to temperature and humidity data acquisition in the environment. . After Arduino treatment, and the treatment results through the LCD display display. When the parameters in the environment reaches the critical value, the alarm will sound the alarmsystem. Use a Arduino-type micro-controller design temperature and humidity control system for, instant accurate reaction greenhouse temperature and moderate changes. Complete, such as the temperature was cooled to a specific temperature,raised to a specific temperature. Maintain constant temperature and other control in the volatility temperature range, humidity control is also true. The application of this system to the greenhouse which is no doubt that provides a more suitable environment for vegetation growth. For greenhouse cultivation and flower garden, flower cultivation, you must install certain environmental temperature and humidity device monitor. This sys