硅棒碰壁检测器的研究与设计-控制科学与工程专业论文.docxVIP

硅棒碰壁检测器的研究与设计 硅棒碰壁检测器的研究与设计 STUDY AND DESIGN ON DETECTOR OF SILICON RODS RUN INTO THE WALL ABSTRACT Reduction furnace is the important equipment of the Siemens Production of polysilicon. It’s temperature is automatic controlled by polysilicon reduction furnace electrical system, electrical system is controlled By SCR voltage control cabinet, and its main equipment is the high-power voltage regulator. During the production process, series of auxiliary functions will be occurred, such as low power factor and harmonic problems, the structure of the circulation problems, silicon rods run into the wall, cleft stick detection and power issues etc.. Silicon rod hitting the wall is one of the problems, when occurred, resulting in the load short-circuit current over-current faults, etc., or even discharge breakdown occurs silicon rod furnace wall, causing enormous losses. Only Russia, the United States, Japan, Germany, France, Israel and other countries to master the fault detection technology, the current domestic polysilicon has not been able to detect run into a wall of the device, only through artificial guards, or the introduction of Germany advanced countries of the detection equipment, therefore, developed a test device has great significance in polysilicon production areas of our country . Reduction furnace silicon rod resistance caused by large-scale change in voltage regulator output voltage and current adjustment range is a big booster of the design features, while the voltage is not controllable causing the phenomenon of direct measurement difficult. In this paper, pairs of poly-silicon reduction furnace electrical system studies, rebuffed this phenomenon for silicon rods, designed a devices to automatically detect the phenomenon of poly-silicon run into a wall. Detector according to the low-pass high resistance characteristics of capacitance elements, eliminating the changes in frequency brought about a wide range of voltage is not controllable through the detec